Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Plastics & Elastomers Functions
- Technologies
- Product Families
- Composition
Proprietary synergistic blend of organic fatty acids, esters and amine combined with wetting agents.
Features & Benefits
- Materials Features
Applications & Uses
- Markets
- Compatible Polymers & Resins
- Plastics & Elastomers Processing Methods
- Use Level
- 1 to 10 Parts Per 1000 Resin
- Recommended Uses
- Epoxy
- Acid/anhydride cure
- Imidazole cure
- Epoxy
- Application Method
General:
For best results, laboratory tests or pre-production trials should determine the optimum addition level. MoldWiz process aid additives are effective within a range of 1 to 10 parts per 1000 resin by weight, excluding reinforcements, pigments and fillers. High amounts of filler may require a higher percentage of process aid additive than the indicated maximum. Always start an evaluation at 5 parts per 1000 (0.5%). Too much additive may retard the cure. Reduce the level of additive or slightly increase the catalyst. For additional information, refer to Process Aid Additives / Thermoset Resins – Testing Procedures.
Mixing:
For two-part thermoset resins, mix the process aid additive in the less viscous or less reactive side before catalyzing.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Effective Ingredients | 100.0 | % | - |
| Flash Point (C.O.C) | min. 350 / min. 177 | °F/°C | - |
| pH | 6.5 | - | - |
| Refractive Index | 1.475 | - | - |
| Solids | 100.0 | % | - |
| Specific Gravity (25°C) | 0.994 | - | - |
| Viscosity at 25°C | 250 - 650 | cPs | - |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Country Availability
- Regional Availability