Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Compatible Substrates & Surfaces
- Direction for Use
- Part A and B need to be mixed thoroughly in the correct volume ratio for 1 minute before use. Gel time of the mixed product is 4–6 minutes at room temperature.
- Parts requiring bonding should be assembled and kept close without any stress. Assembling is continued until full curing takes place.
- Excess of the product can be cleaned with Acetone or any solvent-based cleaner compatible with the substrates to bond.
- For best results, it is recommended to scratch (if possible) the surface, then gently degrease and clean the excess material off the area.
NOTE: Shear strength will increase roughly to 25 – 27 N/mm² if bonding parts are allowed to cure 15 minutes at room temperature 25°C (77°F) followed by 2 hours cure at 100°C (212°F) (if possible).
- Common Applications
- Modeling hobbies
- Wood working
- Toy repairs
- Car part repairs
- 3D printing bonding
- Framing repairs
- Glass repairs
- Furniture repair/manufacturing
- Ceramic repairs
- Jewelry application
Properties
- Physical Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Composition (Part A, Resin) | Epoxy Resin | — | — |
| Viscosity (Part A, Resin, 25°C) | 14000 - 18000 | — | — |
| Specific Gravity (Part A, Resin, 25°C) | 1.19 | — | — |
| Mixing Ratio (Part A, Resin, Volume) | 1.0 | — | — |
| Composition (Part B, Hardener | Polymercaptan | — | — |
| Viscosity (Part B, Hardener, 25°C) | 12000 - 14000 | — | — |
| Specific Gravity (Part B, Hardener, 25°C) | 1.12 | — | — |
| Mixing Ratio (Part B, Hardener, Volume) | 1.0 | — | — |
| Value | Units | Test Method / Conditions | |
| Pot Life (Time Detected using 6g Total Mass) | 4.0 - 6.0 | min | — |
| Cure Time (Functional) | 25 - 35 | min | — |
| Mixing Colour | Colorless/Clear | — | — |
| Shear Strength | 11.0 - 15.0 | N/mm² | ISO 4587 |
| Hardness | 75 - 80 | Shore D | — |
| Gap to Fill | 0.1 - 2.1 | mm | — |
Technical Details & Test Data
- Chemical Resistance (After 24 Hours From Curing)
Chemical Temperature After 100 Hours After 500 Hours Motor Oil 40°C EX EX Water 25°C EX EX Cooling Gas 25°C EX EX Gasoline 25°C EX EX
Storage & Handling
- Storage
Product must be kept in a cool and dry room at 10°C to 25°C.
- Shelf Life
Minimum two years in unopened packaging at +5°C/+27°C.