Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Chemical Name
- CASE Ingredients Functions
- Composite Materials Functions
- CAS No.
- 872-50-4
- EC No.
- 212-828-1
- Technologies
Features & Benefits
- CASE Ingredients Features
- Materials Features
- Benefits
Coatings produced from SR3602-37W provide :
- Excellent thermal stability (polymer will typically withstand temperature excursions of >250°C).
- High level of chemical resistance.
- Good abrasionresistance.
- FDA compliance.
Applications & Uses
- Applications
- Compatible Substrates & Surfaces
- Coating Type
- Applications
SR3602-37W is typically used in the following applications :
- Temperature resistant coatings.
- Binder for high temperature resistant fiber reinforcedplastics.
- Bonding agent for high temperature applications up to 240°C.
- FDA compliantcoatings.
- The excellent chemical resistance of these polymers leads to applications in container coatings, “non- stick” cookware, electronics, and other areas.
- Coatings can be produced from SR3602-37W that meet requirements of FDA regulations 177.2450 and can therefore be used in the manufacture of cookwarecoatings.
Solvent System
The solvent in this material is N-methylpyrrolidone, further thinning if required should be carried out with N-methylpyrrolidone. This solvent can also be used for cleaning of equipment as necessary.
- Processing
- SR3602-37W is supplied as a solution, care must be taken to enable the solvent to be removed slowly to avoid blistering of the film.
- During curing, the temperature of the object should be increased slowly up to the final cure temperature to avoid blistering of the coating due to final release of solvent. Final cure temperature of >220°C is required.
- The solvent system for SR3602-37W is hygroscopic, i.e., will slowly absorb moisture from the atmosphere.
- 1-2% water content should not affect performance, but higher levels will lead to thickening of the product and difficulty in obtaining an acceptable impregnation.
- For this reason the applicator tank should be closed.
- It is advised not to mix used material with unused product for storage, although topping-off the process tank with fresh material is acceptable.
Properties
- Color
- Appearance
- Viscous red/brown liquid
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Viscosity (23°C) | 4000 - 6000 | mPas | — |
| Non-Volatiles | 34 - 36 | % | — |
| Density (23°C) | approx. 1.1 | g/mL | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Regulatory Information
- This product meets the definition of a polymer under REACH, and its components are registered as substances.
- The material, or components, is either on the TSCA inventory list or is exempt from the requirement to be listed.
Storage & Handling
- Shelf Life
- 18 months
- Storage
- In the original sealed container these products have a shelf life of 18 months when stored below 35°C.
- Solution viscosity will increase over time. The rate of increase depends upon solvent, % solids and storage conditions.
- The increase in viscosity does not affect polymer performance.
- The viscosity can be adjusted with additional solvent and the material can be used with no performance loss.