Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- IRAC Code
- Agrochemical Functions
- Technologies
- Product Families
- Composition
Intended For Agricultural or Commercial Use.
ACTIVE INGREDIENT:
Carbaryl - 42.6%
OTHER INGREDIENTS - 57.4%
Applications & Uses
- Markets
- Applications
- Applicable Crop
- Application Technique
- Direction For Use
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read the entire label before using this product. Strictly observe label directions and precautions. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
Properties
- Formulation Type
Safety & Health
- Precautionary Statements
Hazards to Humans and Domestic Animals
CAUTION: Harmful if swallowed, absorbed through skin, or inhaled. Avoid breathing spray mist. Avoid contact with skin, eyes, or clothing. OVEREXPOSURE MAY CAUSE: Salivation, watery eyes, pinpoint eye pupils, blurred vision, muscle tremors, difficult breathing, excessive sweating, abdominal cramps, nausea, vomiting, diarrhea, weakness or headache.
IN SEVERE CASES, CONVULSIONS, UNCONSCIOUSNESS AND RESPIRATORY FAILURE MAY OCCUR. SIGNS AND SYMPTOMS MAY OCCUR RAPIDLY FOLLOWING OVEREXPOSURE TO THIS PRODUCT.
PERSONAL PROTECTIVE EQUIPMENT (PPE)
Some materials that are chemical-resistant to this product are made of any waterproof material.
Handlers applying with open cab airblast equipment at application rates equal to or greater than 5 quarts of this product (5 lbs. a.i.) must wear: Coveralls over long-sleeved shirt and long pants, chemical-resistant gloves made of barrier laminate, butyl rubber ≥ 14 mils, nitrile rubber ≥ 14 mils, neoprene rubber ≥ 14 mils, natural rubber ≥ mils, polyethlene, polyvinyl chloride ≥ 14 mils or viton ≥ 14 mils, chemical-resistant footwear plus socks, chemical-resistant headgear and a NIOSH approved particulate respirator with any N, R or P filter, NIOSH approval number prefix TC-84A or a NIOSH approved powered air purifying respirator with an HE filter with NIOSH approval number prefix TC-21C.
All other mixers, loaders, applicators and handlers must wear: Long-sleeved shirt and long pants, shoes plus socks, chemical-resistant gloves and a chemical-resistant apron when mixing, loading or cleaning up spills or equipment. In addition, mixers and loaders supporting aerial or chemigation applications must wear a NIOSH approved dust / mist filtering respirator with a NIOSH approved particulate respirator with any N, R or P filter, NIOSH approval number prefix TC-84A; or a NIOSH approved powered air purifying respirator with an HE filter with NIOSH approval number prefix TC-21C.
See “ENGINEERING CONTROLS” for additional requirements and exceptions. Follow manufacturer’s instructions for cleaning and maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry.
Discard clothing and other absorbent materials that have been drenched or heavily contaminated with this product’s concentrate. Do not reuse them.
- Engineering Controls
Pilots must use an enclosed cockpit in a manner that is consistent with the WPS for Agricultural Pesticides [40 CFR 170.240(d)(6)]. Applicators using airblast equipment for application to Citrus in California and for wide area mosquito adulticide applications must use an enclosed cab that meets the definition in the WPS for Agricultural Pesticides [40 CFR 170.240(d)(5)] for dermal protection. In addition, such applicators must:
- wear long-sleeved shirt, long pants, shoes and socks;
- either wear a NIOSH approved particulate respirator with any N,
R or P filter, NIOSH approval number prefix TC-84A; or a NIOSH approved powered air purifying respirator with an HE filter with NIOSH approval number prefix TC-21C or use an enclosed cab that is declared in writing by the manufacturer or by a government agency to provide at least as much respiratory protection as this type of respirator; be provided, have immediately available for use, and wear in an emergency when they must exit the cab in the treated area coveralls, chemical-resistant gloves, chemical-resistant footwear and chemical-resistant headgear (if overhead exposure) plus – if not already using one – the respirator specified above;
- take off any PPE that was worn in the treated area before re-entering the cab, and
- store all such PPE in a chemical-resistant container, such as a
plastic bag, to prevent contamination of the inside of the cab. Human flagging is prohibited, except for flagging to support ultra low volume aerial applications for Rangeland Grasshopper and Mormon Cricket Suppression through the Animal and Plant Health Inspection Service (APHIS) Program or affiliated State programs. Flagging to support aerial application for all other use patterns is limited to the use of Global Positioning System (GPS) or mechanical flaggers. Flaggers supporting ultra low volume aerial applications for Rangeland Grasshopper and Mormon Cricket Suppression through APHIS program or affiliated State programs must use an enclosed cab that meets the definition in the WPS for Agricultural Pesticides [40 CFR 170.240(d)(5)] for dermal protection. In addition, flaggers must:
- wear long-sleeved shirt, long pants, shoes and socks;
- either wear a NIOSH-approved dust / mist filtering respirator with a NIOSH approved particulate respirator with any N, R or P filter, NIOSH approval number prefix TC-84A; or a NIOSH approved powered air purifying respirator with an HE filter with NIOSH approval number prefix TC-21C or use an enclosed cab that is declared in writing by the manufacturer or by government agency to provide at least as much respiratory protection as this type of respirator;
- be provided, have immediately available for use, and wear in an emergency when they must exit the cab in the treated area: chemical-resistant gloves and chemical-resistant headgear and, if using an enclosed cab that provides respiratory protection, a respirator of the type specified above;
- take off any PPE that was worn in the treated area before re-entering the cab; and
- store all such PPE in a chemical-resistant container, such as plastic bag, to prevent contamination of the inside of the cab.
When applicators use enclosed cabs in a manner that meets the requirements listed in the WPS for Agricultural Pesticides [40 CFR 170.240(d)(5)], the handler PPE requirements may be reduced or modified as specified in the WPS.
- User Safety Recommendations
Users should:
1) Wash hands thoroughly with soap and water before eating, drinking, chewing gum, using tobacco or using the toilet.
2) Remove clothing / PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing.
3) Remove PPE immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into clean clothing.
- Environmental Hazards
This product is extremely toxic to aquatic invertebrates. For terrestrial uses, do not apply directly to water or to areas where surface water is present or to intertidal areas below the mean high water mark. Discharge from Rice fields may kill aquatic and estuarine invertebrates. Do not apply when weather conditions favor drift from area treated. Drift and runoff may kill aquatic invertebrates in water adjacent to treated areas. Do not contaminate water by cleaning equipment or disposal of wastes. Do not contaminate water when disposing of washwaters.
BEE CAUTION: May kill honeybees and other bees in substantial numbers. This product is highly toxic to bees exposed to direct treatment or residues on crops or weeds in bloom.
Notifying beekeepers within 1 mile of treatment area at least 48 hours before product is applied will allow them to take additional steps to protect their bees.
Limiting applications to times when bees are least active, e.g., within 2 hours of sunrise or sunset, will minimize risk to bees.
For crops in bloom (except Corn and Soybeans):
Do not apply this product to target crops or weeds in bloom.
For Corn and Soybeans:
If application cannot be avoided when target crop or weeds are in bloom, limiting applications to times when bees are least active, e.g., within 2 hours of sunrise or sunset, will minimize risk to bees.
Packaging & Availability
- Packaging Type
Storage & Handling
- Storage And Disposal
Do not contaminate water, food or feed by storage or disposal.
Open dumping is prohibited.
PESTICIDE STORAGE: Store unused product in original container only, in cool, dry area out of reach of children and animals. Do not store in areas where temperatures frequently exceed 100°F. If container is damaged, before cleaning up, put on Personal Protective Equipment (PPE).
PESTICIDE DISPOSAL: To avoid waste, use all materials in this container by application according to label directions. If wastes cannot be avoided, offer remaining product to a waste disposal facility or pesticide disposal program (often, such programs are run by State or local governments or by industry).
CONTAINER DISPOSAL:
Nonrefillable Container (rigid material; less than 5 gallons): Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available. Clean container promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container one-fourth full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Dispose of empty container in a sanitary landfill or by incineration, or, if allowed by State and local authorities, by burning. If burned, stay out of smoke.
Nonrefillable Container (rigid material; 5 gallons up to < 250 gallons): Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available. Clean container promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container one-fourth full with water. Replace and tighten closures. Tip container on its side and roll it back and forth, ensuring at least one complete revolution, for 30 seconds. Stand the container on its end and tip it back and forth several times. Turn the container over onto its other end and tip it back and forth several times. Empty the rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Repeat this procedure two more times. Dispose of empty container in a sanitary landfill or by incineration, or if allowed by State and local authorities, by burning. If burned, stay out of smoke.
Refillable Container (≥ 250 gallons & Bulk): Refillable container. Refill this container with pesticide only. Do not reuse this container for any other purpose. Cleaning the container before final disposal is the responsibility of the person disposing of the container. Cleaning before refilling is the responsibility of the refiller. To clean the container before final disposal, empty the remaining contents from this container into application equipment or mix tank. Fill the container about 10% full with water. Agitate vigorously or recirculate water with the pump for 2 minutes. Pour or pump rinsate into application equipment or rinsate collection system. Repeat this rinsing procedure two more times.