Trizmet™ II is a selective herbicide designed to control problematic grasses and broadleaf weeds in Field corn, Popcorn and Sweet corn.

Functions: Herbicide

Herbicide Target Species: Broadleafs, Grasses

HRAC/WSSA Group: 15, 27, 5

Application Technique: Post-Emergence, Pre-Emergence, Sprayers

Formulation Type: Concentrate Solutions

    Knowde Enhanced TDS

    Identification & Functionality

    HRAC/WSSA Group
    Agrochemical Functions
    Technologies
    Composition

    ACTIVE INGREDIENT

    Atrazine - 33.1%

    Atrazine Related Compounds -0.6%

    Metolachlor -26.1%
    OTHER INGREDIENT - 40.2%

    Applications & Uses

    Applicable Crop
    Herbicide Target Species
    User Safety Recomendation

    USER SAFETY RECOMMENDATIONS

    Users should: 1) Wash hands before eating, drinking, chewing gum, using tobacco or using the toilet.

    2) Remove clothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing.

    3) Remove PPE immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into clean clothing.

    Direction For Use

    RESTRICTED USE PESTICIDE. For retail sale to and use only by certified applicators or persons under their direct supervision and only for those uses covered by the certified applicator’s certification. This product is a restricted use herbicide due to ground and surface water concerns. Users must read and follow all precautionary statements and instructions for use in order to minimize potential for Atrazine to reach ground and surface water.

    It is a violation of federal law to use this product in a manner inconsistent with its labeling.

    Agricultural Use Requirements

    Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part 170. This standard con-tains requirements for the protection of agricultural workers on farms, forests, nurseries, greenhouses and handlers of agricultural pesticides. It contains requirements for training, decontamination, notification and emergency assistance. It also contains specific instructions and exceptions pertaining to the statements on this label about Personal Protective Equipment (PPE) and Restricted Entry Interval (REI). The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard.

    Do not enter or allow worker entry into treated areas during the restricted entry interval of 48 hours. For greenhouse uses, do not enter or allow worker entry into treated areas during the REI of 24 hours.

    For at least seven days following the application of Copper-contain-ing products in greenhouses:

    •  at least one container or station designed specifically for flushing eyes is available in operating condition with the WPS-required decontamination supplies for workers entering the area treated with Copper-containing products,

    •  workers are informed orally, in a manner they can understand:

    –  that residues in the treated area may be highly irritating to their eyes,

    –  that they should take precautions, such as refraining from rub-bing their eyes, to keep the residues out of their eyes,

    –  that if they do get residues in their eyes, they should immedi-ately flush their eyes with the eye flush container that is located with the decontamination supplies and

    – how to operate the eye flush container or eye flush station.

    PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with any-thing that has been treated, such as plants, soil or water is: Coveralls, chemical-resistant gloves made of any waterproof material, shoes plus socks and protective eyewear.

    Properties

    Formulation Type

    Safety & Health

    Precautionary Statements

    Hazards to Humans and Domestic Animals

    CAUTION: Harmful if swallowed, inhaled or absorbed through skin.

    Causes moderate eye irritation. Avoid contact with skin, eyes or clothing. Avoid breathing spray mist.

    PERSONAL PROTECTIVE EQUIPMENT (PPE)

    Some materials that are chemical-resistant to this product are listed below.

    Applicators and other handlers must wear: Long-sleeved shirt and long pants, chemical-resistant gloves made of any waterproof material (such as Natural Rubber), shoes, socks and protective eyewear.

    Follow manufacturer’s instructions for cleaning / maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry.

    ENGINEERING CONTROLS

    When handlers use closed systems, enclosed cabs, or aircraft in a manner that meets the requirements listed in the Worker Protection Standard (WPS) for Agricultural Pesticides [40 CFR 170.240(d)(4-6)], the handler PPE requirements may be reduced or modified as specified in the WPS.

    Engineering Controls

    Mixers and loaders supporting aerial applications must use a closed system that meets the requirements for dermal protection listed in the Worker Protection Standard (WPS) for Agricultural Pesticides [40 CFR 170.240(d)(4)] and must:

    •wear the PPE required above for mixers and loaders,

    •wear protective eyewear if the system operates under pressure,and

    •be provided and have immediately available for use in anemergency, such as a spill or equipment breakdown: chemical-resistant footwear.

    Pilots must use an enclosed cockpit in a manner that is consistent with the WPS for Agricultural Pesticides [40 CFR 170.240(d)(6)]. Pilots must wear the PPE required on this labeling for applicators, however, they need not wear chemical-resistant gloves when using an enclosed cockpit.Flaggers supporting aerial applications must use an enclosed cab that meets the definition on the WPS for Agricultural Pesticides [40 CFR 170.240(d)(5)] for dermal protection.When applicators use enclosed cabs in a manner that meets the requirements listed in the WPS for Agricultural Pesticides [40 CFR 170.240(d)(4-5)], the handler PPE requirements may be reduced or modified as specified in the WPS.

    Environmental Hazards

    This pesticide is toxic to aquatic invertebrates. Do not apply directly to water, to areas where surface water is present, or to intertidal areas below the mean water mark. Do not apply when weather conditions favor drift from treated areas. Runoff and drift from treated areas may be hazardous to aquatic organisms in neighboring areas. Do not contaminate water when disposing of equipment washwater.

    Groundwater Advisory ; This product contains the active ingredients Metolachlor, Atrazine and Mesotrione.Atrazine can travel (seep or leach) through soil and can enter groundwater which may be used as drinking water. Atrazine has been found in groundwater. Users are advised not to apply Atrazine to Sand and Loamy sand soils where the water table (groundwater) is close to the surface and where these soils are very permeable, i.e., well-drained. Your local agricultural agencies can provide further information on the type of soil in your area and the location of groundwater from runoff. Runoff of this product will be reduced by avoiding applications when rainfall is forecasted to occur within 48 hours. Sound erosion control practices will reduce this product’s contribution to surface water contamination.Metolachlor has the potential to leach through soil into groundwater under certain conditions as a result of agricultural use. Use of this chemical in areas where soils are permeable, particularly where the water table is shallow, may result in groundwater contamination.

    Surface Water Advisory ; The active ingredients in this product have the potential to contaminate surface water through ground spray drift. Under some conditions, the active ingredients may also have a high potential for runoff into surface water (primarily via dissolution in runoff water) for several months post-application. These include poorly drained or wet soils with readily visible slopes toward adjacent surface waters, frequently flooded areas, areas overlaying extremely shallow groundwater, areas with in-field canals or ditches that drain to surface water, areas not separated from adjacent surface waters with vegetated filter strips, and areas overlaying tile drainage systems that drain to surface water.A level, well maintained vegetative buffer strip between areas to which this product is applied and surface water features such as ponds, streams and springs will reduce the potential for contamination of water from runoff. Runoff of this product will be reduced by avoiding applications where rainfall is forecasted to occur within 48 hours. Sound erosion control practices will reduce the contribution of this product to surface water contamination.

    Packaging & Availability

    Packaging Type

    Storage & Handling

    Storage And Disposal

    Do not contaminate water, food or feed by storage or disposal.

    PESTICIDE STORAGE: Store in original container. This product will freeze at a temperature of approximately 5ºF, but upon warming, will thaw out to a fully homogeneous product.

    PESTICIDE DISPOSAL: Wastes resulting from the use of this product may be disposed of on site or at an approved waste disposal facility.

     

    CONTAINER HANDLING:

    Nonrefillable Container (rigid material; less than 5 gallons):Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available. Clean container promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container one-fourth full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Dispose of empty container in a sanitary landfill or by incineration, or, if allowed by State and local authorities, by burning. If burned, stay out of smoke.

    Nonrefillable Container (rigid material; 5 gallons up to < 250 gallons): Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available. Clean container promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container one-fourth full with water. Replace and tighten closures. Tip container on its side and roll it back and forth, ensuring at least one complete revolution, for 30 seconds. Stand the container on its end and tip it back and forth several times. Turn the container over onto its other end and tip it back and forth several times. Empty the rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Repeat this procedure two more times. Dispose of empty container in a sanitary landfill or by incineration, or if allowed by State and local authorities, by burning. If burned, stay out of smoke.

    Refillable Container (≥ 250 gallons & Bulk): Refillable container. Refill this container with pesticide only. Do not reuse this container for any other purpose. Cleaning the container before final disposal is the responsibility of the person disposing of the container. Cleaning before refilling is the responsibility of the refiller. To clean the container before final disposal, empty the remaining contents from this container into application equipment or mix tank. Fill the container about 10% full with water. Agitate vigorously or recirculate water with the pump for 2 minutes. Pour or pump rinsate into application equipment or rinsate collection system. Repeat this rinsing procedure two more times. Then offer for recycling if available or reconditioning if appropriate or puncture and dispose of in a sanitary landfill, or by other procedures approved by State and local authorities.