Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- HRAC/WSSA Group
- Agrochemical Functions
- Technologies
- Product Families
- Composition
- ACTIVE INGREDIENT
- fenoxaprop-p-ethyl: (+)-ethyl 2-[4-[(6-chloro-2-benzoxazolyl)oxy] phenoxy]propanoate - 6.70%
- INERT INGREDIENTS - 93.30%
- Total - 100.00%
Features & Benefits
- Product Highlights
- Broad spectrum grass control inclduing barnayrdgrass, sprangletop, broadleaf singalgrass and others
- Labeled for use pre and post-emergent flood
- Proven safety to rice
Applications & Uses
- Markets
- Applications
- Applicable Crop
- Application Technique
- Herbicide Target Species
- Directions For Use
- It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
- Do not apply until you have read the entire label . Do not apply this product in away that will contact workers or other persons, either directly or through drift . Onlyprotected handlers may be in the area during application .For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation .
Properties
- Physical Form
Safety & Health
- Hazards To Humans And Domestic Animals
- Causes substantial but temporary eye injury . Harmful if swallowed . Do not get in eyes, or on clothing . Wear protective eyewear (goggles, face shield, or safety glasses) . Wash thoroughly with soap and water after handling . Remove contaminated clothing and wash clothing before reuse .
- Personal Protective Equipment (PPE)
Some materials that are chemical-resistant to this product are listed below . If you want more options, follow the instructions for category G on an EPA chemical resistance category selection chart .
Applicators and other handlers must wear:
- Long-sleeved shirt and long pants
- Protective eyewear
- Shoes and socks
Follow manufacturer’s instructions for cleaning/maintaining PPE . If no such instructions for washables, use detergent and hot water . Keep and wash PPE separately from other laundry .
- Engineering Controls
- When handlers use closed systems, enclosed cabs, or aircraft in a manner that meets the requirements listed in the Worker Protection Standard (WPS) for agricultural pesticides [(40 CFR 170 .240(d)(4-6)], the handler PPE requirements may be reduced or modified as specified in the WPS
- User Safety Recommendations
Users should:
- Wash hands before eating, drinking, chewing gum, using tobacco or using the toilet .
- Remove clothing immediately if pesticide gets inside . Then wash thoroughly and put on clean clothing .
- Remove PPE immediately after handling this product . Wash the pesticide off of gloves before removing . As soon as possible, wash thoroughly and change into clean clothing .
- Environmental Hazards
- This pesticide is toxic to fish, shrimp and oysters . Do not apply directly to water or toareas where surface water is present or to intertidal areas below the mean high water mark except as indicated in the directions for use on rice . Do not contaminate arable land and/or water when disposing of equipment wash water or rinsate .
Storage & Handling
- Storage and Disposal
- DO NOT contaminate water, food, or feed by storage, disposal or cleaning of equipment.
- PESTICIDE STORAGE: Store in original container away from feed and food. Store in cool, dry area. Do not store in direct sunlight. Do not allow prolonged storage in temperatures that exceed 105°F (40°C) or in temperatures that fall below 14°F (-10°C).
- PESTICIDE DISPOSAL: To avoid wastes, use all material in this container by application according to label directions. If wastes cannot be avoided, offer remaining product to a waste facility or pesticide disposal program (often such programs are run by state or local governments or by industry).
- CONTAINER HANDLING: Rigid, Non-refillable containers (equal to or less than 5 gallons)Non-refillable container. Do not reuse or refill this container. Offer for recycling, if available. Triple rinse or pressure rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container 1/4 full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times.Pressure rinse as follows: Empty the remaining contents into application equipment or a mix tank and continue to drain for 10 seconds after the flow begins to drip. Hold container upside down over application equipment or mix tank or collect rinsate for later use or disposal. Insert pressure rinsing nozzle in the side of the container, and rinse at about 40 PSI for at least 30 seconds. Drain for 10 seconds after the flow begins to drip.Once container is rinsed, offer for recycling if available or puncture and dispose of in a sanitary landfill.