Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
Features & Benefits
- Ready-to-Use Product Features
- Product Highlights
- Two-part, red, pourable silicone system
- 10:1 Mix Ratio (Part A:B)
- Cures at room temperature or rapidly with heat
- High tear strength and good physical properties
Applications & Uses
- Applications
- Application Area
- Cure Method
- Applications
- As a high temperature adhesive / sealant
- Ideal for use in potting connectors, cable harness breakouts, molded high voltage terminals, seals and gaskets due to its high physical strength
- For applications requiring an operating temperature range of -65°C to 315°C (-85°F to 600°F)
- Instructions for Use
Mixing
Mix in a 10:1 ratio Part A to Part B. Take care to minimize air entrapment during mixing.
Vacuum Deaeration
Remove air entrapped during mixing by common vacuum deaeration procedure, observing all applicable safety precautions. Slowly apply vacuum, up to 28 inches Hg, to a container rated for use and of volume at least four times that of material being deaerated. Hold vacuum until presence of air is no longer evident.
Note: Some bonding applications may require the use of a primer. NuSil Technology CF1-135 silicone primer is recommended.
Adjustable Cure Schedule
Product cures at room temperature and a wide range of elevated temperatures and cure times to accommodate different production needs.
Properties
- Appearance
- Red
- Typical Properties
- Cured Properties
Value | Units | Test Method / Conditions | |
Viscosity | 280,000 (280,000 ) | cP (Mpa*s) | — |
Durometer Type A | 20.0 | — | — |
Dielectric Strength | 500 (19.5 ) | volts/mil (kV/mm) | — |
Elongat ion | 625.0 | % | — |
Mix Rat io | 0.417361111 | — | — |
Non Volat ile Content | 100.0 | % | — |
Operat ing Temperat ure at -65 °C | 315.0 | °C | — |
Specific Gravity | 1.2 | — | — |
Tear | 140 (24.69 ) | ppi (kN/m) | — |
Tensile | 750 (5.17 ) | psi (MPa) | — |
Volume Resistivity | 1.00E+14 | ohmcm | — |
Work Time | 1.5 | hours | — |
Value | Units | Test Method / Conditions | |
Cure System | Platinum | — | — |
Cure at 150 °C | 30.0 | minutes | — |
Packaging & Availability
- Country Availability
- Regional Availability