OpaLene LL F2002A

1 of 13 products in this brand
OpaLene LL F2002A is a butene co-monomer based linear low density grade produced with the latest Ineos Gas Phase polymerization technology.

Polymer Name: Linear Low Density Polyethylene (LLDPE)

Melt Flow Index: 2.0 - 2.0 g/10 min

Technical Data Sheet

Knowde Enhanced TDS

Identification & Functionality

Plastics & Elastomers Functions
Technologies

Features & Benefits

Features
  • Good Mechanical Properties
  • Low gels
  • Easy Processing
  • No Slip & Anti-block additives

Applications & Uses

Plastics & Elastomers End Uses
Recommended Applications
  • Lamination films
  • Stretch cling films
  • Air bubble films
  • Drip Laterals

Properties

Physical Form
Typical Properties
ValueUnitsTest Method / Conditions
Melt Flow Index ( 190°C & 2.16 kg)2g/10 minASTM D1238
Density (23°C)0.92g/cm³ASTM D1505
Tear Strength (MD)3.25g/µmASTM D1922
Tear Strength (TD)7.5g/µmASTM D1922
Tensile Strength at Yield (50mm / min) (MD/TD)11.0/12.0MPaASTM D882
Tensile Strength at Break (50mm / min) (MD/TD)35.0/30.0MPaASTM D882
Elongation at Break (50mm / min) (MD/TD)800/750%ASTM D882
Dart Impact Strength, F50 (38mm dart, 66cm height)3g/µmASTM D1709

Regulatory & Compliance

Regulatory Requirements

LLDPE film grade F2002A shall meet the requirements stipulated in IS 10146:1982 on 'Specification of Polyethylene for safe use in contact with Foodstuff, Pharmaceutical & Drinking water'. The grade and Additives incorporated in this grade shall meet the positive list of constituents as prescribed in IS 10141:1982. The Grade and the additives incorporated in it shall als°Comply with the FDA: CFR Title 21,177.1520, Olefin Polymers.

Safety & Health

Health and Safety Information

The product described herein may require precautions in handling and use because of toxicity, flammability, or other consideration. The Material Safety Data Sheet (MSDS) contains the available product health and safety information for this material and can be found at www.opalindia.in. Before using any material, a customer is advised t°Consult the MSDS for the product under consideration for use.

Storage & Handling

Storage & Handling

Prevent Polyethylene Material from direct exposure to sunlight & heat to avoid quality deterioration. The storage location should be dry, dust free and the Storage temperature should not exceed 50 °C. Non - compliance to these precautionary measures can lead to degradation of the product causing Color changes, Odor & inadequate product performance