Knowde Enhanced TDS
Identification & Functionality
- Technologies
Features & Benefits
- Product Information
Controls a wide range of brushweeds.
ACTIVE INGREDIENT: 100 g/liter picloram as the amine salt and 300 g/liter triclopyr as the butoxyethyl ester in the form of an emulsifiable concentrate.
- General Information
Gun: Refer to table. Ensure full coverage of leaves and stems. Use a no. 6 – 8 tip, and pressures 1000 – 2000 kPa. Aerial: Refer to table. Use in 200 – 400 liters of water per hectare using the half overlap – opposite pass technique. Follow up ground treatment may be required. Knapsack: Use 6 mL of Synergy Brushkiller per liter of water. Ensure full coverage of leaves and stems. Mistblower: Use 100 mL of Synergy Brushkiller per 10 liters. For ULV applications, use 500 mL per 10 liters. Ensure full coverage of leaves and stems. Stump Swabbing: Mix 1 part Synergy Brushkiller to 20 parts water or diesel. Liberally coat the freshly cut surfaces and stems to ground level.
Applications & Uses
- Markets
- Spillage
Extinguish any ignition sources. Exclude non-essential people from the area. Wear protective clothing and prevent material from entering waterways. Absorb spill with inert material such as soil, sand, etc, and place in a waste container. Wash area with water and detergent, and absorb with further inert material. Dispose of safely to a suitable landfill.
- Mixing
Mix the required quantity in the spray tank partly filled with water, and maintain agitation through filling and spraying.
- Drift
The addition of a suitable drift control agent such as Synergy Low Drift is recommended to reduce spray drift onto non-target species.
- Withholding Periods
It is an offense for users of this product to cause residues exceeding the relevant MRL in the Food Notice: Maximum Residue Levels for Agricultural Compounds. Poisonous plants may become more palatable after spraying, and livestock should be kept out until plants have died down
- Resistance Management
GROUP O3 HERBICIDE
Synergy Brushkiller contains the active ingredients picloram and triclopyr, both of which belong to the pyridine carboxylic acid chemical family. Some naturally occurring weeds may become resistant when excessive use of the same herbicide occurs. To prevent or delay the development of resistance, use in tank mixes and/or rotate use with herbicides with a different mode of action. Consult http://resistance.nzpps.org/index.php for alternative modes of action and details of resistance management strategies (if any) for the uses listed on the label.
- Directions For Use
Weed Rate – Gun mL/100 L water Rate – Aerial Liter/Ha Critical Comments Blackberry 500 - 650 10 Spray in summer to early autumn when actively growing. Use higher rates for low growing and hard grazed plants in Northland and NI East Coast. Some types may be difficult to kill. Broom 250 10 Spray in spring to early summer when leaves are present. Control is best on smaller bushes less than 3 m high, with stems less than 3 cm diameter. Hard grazed or scattered bush should be ground sprayed. Gorse 250 10 Ground: During periods when plants are dormant, or growth is slow, eg, under hot, dry, cold or dusty conditions, or when plants have been grazed or slashed, apply with Synergy Penetrant at 100mL per 100 liters of spray mix. Follow up treatment may be necessary for complete control. Aerial: Apply with Synergy Penetrant at 2 liters per hectare during active growth. Control is best on smaller bushes less than 3 m high, with stems less than 3 cm diameter. Hard grazed or scattered bush should be ground sprayed. Gorse (North Canterbury) 300 10 Ground: Apply with Synergy Penetrant at 100mL per 100 liters of spray mix. Follow up treatment may be necessary for complete control. Aerial: As above Lupin 100 2 Matagouri 500 12 Best results are achieved in November / December under moist growing conditions and when in full flower. Control may be reduced in dry conditions or where lichen is present on bark. Sweet Brier 300 - 500 12 Best results are achieved in November to early January during leaf emergence to green hip stage. Ground: Thoroughly wet the crown. Aerial: Best results are achieved on bushes less than 2 m high. Tutu 300 10 Apply to fresh regrowth when fronds have expanded. Wooly Nightshade 250 10 Apply during active growth. Best results are achieved by adding Synergy Penetrant at 100 mL per 100 liters of spray mix. Other Weeds 250 Eg, Fennel, Inkweed, Nettle, Ragwort, Thistles, etc For Forestry Radiata pine aerial release spraying:
Weed Rate – Aerial Liter/Ha Critical Comments Broom, Buddleja, Gorse, Himalayan Honeysuckle, 1 - 2 Only use the high rate on dormant trees, and within one year of planting. Brushweeds will only be suppressed, and follow up treatment may be necessary. Some minor twisting of the pines may occur.
Properties
- Physical Form
Technical Details & Test Data
- Compatibility
Synergy Brushkiller is compatible with most commonly used herbicides.
Safety & Health
- Precautions
APPROVED HANDLER: This product must be under the control of an approved handler during use. STORAGE: Keep out of reach of children. Do not store near heat, flame or other source of ignition. Store in the original, tightly closed container, in a cool, well ventilated and secure area away from food, feed, seed, fertilizers, and other crop protection products. Storage of certain quantities of this product trigger specific storage requirements (Refer to Safety Note). When stored appropriately this product should show no significant degradation for two years from the date of manufacture. Contact your supplier for further information about the use of product that is older than this. PERSONAL PROTECTION: Avoid contact with eyes and skin. Avoid inhalation of vapor or spray mist. When mixing or applying, wear overalls, boots, gloves and eye protection. Clean protective clothing daily after work. Do not eat, drink or smoke while using. Remove protective clothing and wash hands and face thoroughly before meals and after work. USE: Avoid handling, mixing or use of the undiluted product or container near heat, flame or other source of ignition. Apply with well maintained and calibrated spray equipment. DISPOSAL: Dispose of this product only by using in accordance with this label, or at a suitable landfill. Do not burn. Triple rinse container and add rinsate to the spray tank. Dispose of container to a suitable landfill or agricultural recycling scheme. Do not burn. Do not use container for any other purpose. ENVIRONMENTAL: Use this product carefully. Do not contaminate aquatic environments with product, spray drift or empty container. Spray drift or equipment contamination may cause serious damage to desirable plants. Do not allow spray drift outside the target area to occur.
Packaging & Availability
- Packaging Type