PROGILINE® AIR 8068

1 of 22 products in this brand

Product Type: Oil

Application Area: Compressors

Features: Anti-Wear Properties, Biodegradable, Chemical Resistant, Corrosion Resistant, Cost Effective, Excellent Lubricity, Good Thermal Stability, High Performance, High Viscosity Index, Low Volatility, Oxidation Resistant, Service Life Extension

Technical Data Sheet

Knowde Enhanced TDS

Identification & Functionality

Base Oil Type
Product Type

Features & Benefits

Key Attributes
  • Resists oxidation for long system life.
  • Optimized cooling performance resulted in extended service intervals and equipment lifetime.
  • Excellent lubricity, anti-wear property and load-carrying capability.
  • High viscosity index for excellent viscosity-temperature behavior thereby always ensuring adequate lubricant oil film from start-up to maximum operating conditions.
  • Low product volatility and an absence of insoluble residues such as gum, varnish, sludge and coke, resulting in longer lifetime, lower maintenance cost and lower oil consumption rate.
  • Outstanding thermal and chemical and stability.
  • Excellent rust and corrosion protection for longer component life.
  • Readily biodegradable.

Applications & Uses

Markets
Application Area

Properties

ISO Viscosity Grade
Physical Properties
ValueUnitsTest Method / Conditions
ISO Viscosity Grade68.0ASTM D2422
Kinematic Viscosity (at 40°C)65.4mm2/sASTM D445
Kinematic Viscosity (at 100°C)10.8mm2/sASTM D445
Viscosity Index148.0ASTM D2270
Flash Point (COC)min. 260°CASTM D92
Specific Gravity (at 20°C)0.976g/cm3ASTM D4052
Pour Point-40.0°CASTM D97
Ferrous Metal CorrosionPassASTM D665A
Copper Corrosion Test (at 100°, 3hrs)1AASTM D130
4-Ball Wear Scar (40kg, 1hr)0.49mmASTM D4172
Falex Failure Loadmin. 4500lbfASTM D1298
Foam Tendancy (Sequence I, II, III)0/0/0mlASTM D892
Evaporation Loss (at 400°C, 6.5hrs)3.4%ASTM D972
RPVOT Oxidation Test6.0hrsASTM D2272
Compatibility Recommendations

Product should NOT be mixed with mineral oil / PAO – complete drain, flush and refill is required. Product shows solvency towards common alkyd oil-based paints, but epoxy-based paints are typically resistive. If surfaces contacting the lubricant have been painted, they should be monitored for softening and lifting of the paint, and frequent maintenance of filters may be required.

Product is compatible with standard hose and seal materials, and shows preferable compatibility with elastomer types Viton, NBr and Fluoro-rubber.
Elastomers types Neoprene, natural rubber, SBR, Buna-S and Butyl rubber are not recommended.

Regulatory & Compliance

Certifications & Compliance