Products in Commercial: Gears

KEBABLEND / EC FE 190106 PPS is a special compound based on PPS, which is electrically conductive.

Polimersan Plastics Polipom (POM) is one of the most preferred Polymer due to resistance to bending and wearing,.

Semi-crystalline high-performance plastic with very good sliding properties and very good mechanical Properties even under thermal stress. In addition, PEEK is characterized by a excellent chemical resistance.

Plain bearing material based on PPS, PPS + carbon fiber + graphite

GEHR PEEK® can be used at very high temperatures (about +260 °C) and it shows an extraordinary mechanical strength, toughness, hardness, flexural strength, torsional strength. PEEK exhibits excellent chemical resistance, very good dielectric properties up to +260 °C and a very good resistance to all kinds of radiation (even ultraviolet rays only lead to a slight yellow discolouration). PEEK is self-extinguishing properties according to UL 94.

BARLOG plastics GmbH Kebaform® / C 25 H is a new type of POM that was developed specially for sliding and wear applications. Compared to a standard POM copolymer, the material is characterized by a higher crystalline structure and thus better wear properties and a higher melting temperature. Kebaform® / C 25 H improves the sliding and wear behavior solely by modifying the polymer chain and there is no reduction in mechanical properties due to the addition of tribologically active additives. Due to its property profile, Kebaform® / C 25 H is particularly well suited for applications that require good sliding and wear behavior, but do not allow compromises in mechanical properties, e.g. For gears, rollers, plain bearings, guide bushes, etc.

BARLOG plastics GmbH Kebaform® / C 130 H is a new type of POM that was developed specially for sliding and wear applications. Compared to a standard POM copolymer, the material is characterized by a higher crystalline structure and thus better wear properties and a higher melting temperature. Due to its property profile, Kebaform® / C 130 H is particularly well suited for applications that require good sliding and wear behavior, but do not allow any compromises in mechanical properties, e.g. For gears, rollers, plain bearings, guide bushes, etc.

POM copolymer unreinforced, dry blend with color masterbatch green, medium viscosity for injection molding

POM copolymer unreinforced, medium viscosity, UV stabilized

POM copolymer unreinforced, medium viscosity, optimized crystallization behavior

BARLOG plastics GmbH Kebaform® / C FE 161105 is a tribologically optimized POM copolymer which, due to its property profile, is particularly suitable for applications that require good sliding and wear behavior.

POM copolymer unreinforced, medium viscosity for injection molding