Products in Polymers & Resins: Wind Turbine Blades

PRF Composite Materials RS-L135 exhibits good mechanical properties after curing at room temperature. If high temperature strength is not required, finished products made with the selection of hardeners up to RS-H136 may be used without further heat treatment. Post curing (heat treatment) will further enhance the mechanical properties and will also increase the heat resistance.

Biresin® CR80 is a low viscosity epoxy resin system suitable for the production of high performance fiber reinforced composites parts and molds with thermal properties up to 80°C.

PRF Composite Materials RS-M135 is an ultra low viscosity laminating system formulated for use in the manufacture of composite components from glass, carbon and aramid fibers. The system is suitable for components requiring high static and fatigue strength properties using injectin molding (e.g. RTM), vacuum infusion and pultrusion processes. At 25°C the mixed viscosity is approximately 200 mPa s and may be lowered further to a value of 100 - 150 mPa s by warming the resin (see page 5), thus even complicated parts with long flow paths can be injected without difficulty. With a mold temperature of around 30°C, the temperature rise with hardener RS-MH137 remains very slight, allowing thicker parts to be built at elevated temperatures.

Ilkalem AS PV-300T is Bisphenol-A epoxy vinylester thixotropic resin for GRP applications.

Ilkalem AS PV-200 is Bisphenol-A epoxy vinylester resin for GRP applications.

SWANCOR 2591 is a hot-melt epoxy resin with low temperature curing and low exothermic properties. The formula does not contain Diuron and volatile ingredients. It has the characteristics of light weight, excellent mechanical strength, heat resistance and corrosion resistance.

Ilkalem AS PV-300 is Bisphenol-A epoxy vinylester resin for GRP applications.