Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Chemical Name
- Polymer Name
- Technologies
Features & Benefits
Applications & Uses
- Applications
- Compatible Polymers & Resins
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- How to Use
• Injection Molding Processing Guide
Drying Time 2–6 hrs
Drying Temperature 80–100°C
Feed Zone Temperature 170–190°C
Center Zone Temperature 180–200°C
Front Zone Temperature 190–200°C
Nozzle Temperature 190–200°C
Melt Temperature 200°C
Mold Temperature 30–50°C
Injection Speed FAST
These process conditions may vary with individual equipment and processes.
• Secondary Processing
As a thermoplastic material, Si-TPV® material can be secondary processed for ordinary products
• Injection Molding Pressure
The holding pressure largely depends on the geometry, thickness and gate location of the product. The holding pressure should be set to a low value at first, and then slowly increase until no related defects are seen in the injection molded product. Due to the elastic properties of the material, excessive holding pressure may cause serious deformation of the gate part of the product.
• Back pressure
It is recommended that the back pressure when the screw is retracted should be 0.7-1.4Mpa, which will not only ensure the uniformity of melt melting, but also ensure that the material is not severely degraded by shear. The recommended screw speed of Si-TPV® is 100-150rpm to ensure the complete melting and plasticization of the material without material degradation caused by shear heating.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Hardness (15 seconds) | 88.0 | Shore A | ISO 868 |
| Specific Gravity | 1.21 | - | ISO 1183 |
| Melt Flow Index(10 kg ,190°C) | 7.6 | g/10 min | ISO 1133 |
| Modulus of elasticity | 17.2 | MPa | ISO 37 |
| Tensile Strength | 24.0 | MPa | ISO 37 |
| Tensile Stress(100 Elongation) | 8.4 | MPa | ISO 37 |
| Elongation at break | 485.0 | % | ISO 37 |
| Tear Strength | 103.0 | kN/m | ISO 34 |
| Compression Set 22 hours (23°C) | 32.0 | % | ISO 815 |
Packaging & Availability
- Packaging Type
- Packaging
25KG / bag , craft paper bag with PE inner bag.
Storage & Handling
- Handling
A desiccant dehumidifying dryer is recommended for all drying.
Product safety information required for safe use is not included in this document. Before handling, read product and safety data sheets and container labels for safe use, physical and health hazard information. the safety data sheet is available on the silike company website at siliketech.com ,or from distributor, or by calling Silike customer service.
- Storage
Transport as non-hazardous chemical. Store in a cool , well ventilated place. Original characteristics remain intact for 24 months from the production date , if kept in recommend storage.