Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Technologies
Features & Benefits
Applications & Uses
- Applications
- Application Area
- Instructions for Use
- To use, mix at room temperature, 100 grams of EB-155 part A with 82 grams of Hardener Part B and vacuum degas.
- Do not mix more than 200 grams mass due to violent exothermic reaction with evolution of fumes and smoke.
- Apply to clean bonding surfaces and cure as recommended to achieve the desired properties.
- Typical cured properties were determined using recommended cure schedule. Some difference in properties may occur with the alternate or other cure schedules.
Properties
- Typical Cured Properties
- Handling Properties
- Note
Typical Cured Properties After Recommended Cure : Tested at 25°C unless otherwise indicated
Value | Units | Test Method / Conditions | |
Specific Gravity | 1.15 | - | - |
Hardness | 80 | Shore D | - |
Water Absorption (24 hours Submersion at 25°C) | 0.17 | % | - |
Lap Shear Strength to Aluminium | 2700 | psi | - |
Linear Shrinkage | 0.27 | % | - |
Flexural Strength (Yield) | 13500 | psi | - |
Flexural Modulus (Yield) | 3.2x10⁵ | psi | - |
Service Temperature Range | -55 to 120 | °C | - |
Glass Transition Temperature (Tg) | 65 | °C | - |
Coefficient of Linear Thermal Expansion (From -60°C to 25°C) | 59 | 10⁻⁶/°C | - |
Die Shear Strength (at 25°C) | 450 | psi | - |
Dielectric Constant (at 1 kHz) | 4.14 | - | - |
Dissipation Factor (at 1 kHz) | 0.012 | - | - |
Volume Resistivity | 1.05x10¹¹ | ohm-cm | - |
Value | Units | Test Method / Conditions | |
Epoxibond | Part A | - | - |
Hardener | Part B | - | - |
Mix Ratio by Weight (Resin/Hardener) | 100/82 | - | - |
Mix Ratio by Volume (Resin/Hardener) | 1:1 | - | - |
Mixed Viscosity (at 25°C) | 2000 - 3000 | cps | - |
Pot Life (at 25°C, 100 grams) | 45 - 60 | minutes | - |
Regulatory & Compliance
- Certifications & Compliance
Technical Details & Test Data
- Curing Information
- Recommended Cure : 1 hr at 65°C
- Alternate Cure : 24 at 25°C
- Frozen Adhesive
Thaw premixed frozen adhesive at room temperature for 5-10 minutes. Dispense adhesive and cure at recommended schedules.
Safety & Health
- Safety Information
- For Industrial Use Only : Practices of good housekeeping, safety and cleanliness should be followed before, during and after use.
- Warning : Adequate ventilation of workplace and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention. Refer to Safety Data Sheet (SDS) for additional health and safety information.
Packaging & Availability
- Availability
- 2 parts Kit : Packaged in Pint, Quart, Gallon, and 5-Gallon size.
- Premixed and frozen : Packaged in 3cc, 5cc, 10cc and 30cc disposable syringes and ship in dry ice at -80°C.