Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Product Highlights
- Excellent stain blocking.
- Excellent surfacing for enamel holdout.
- Free of lead, mercury, or other toxic pigments.
- Inhibits rust on metal surfaces.
- Extremely blister resistant.
Applications & Uses
- Applications
- Use
As a primer for exterior wood surfaces. This product is extremely blister resistant and will inhibit staining by tannins, mold, or mildew.
- Limitations
This primer also is rust inhibitive when applied to carbon steel surfaces. Do not apply below 45°F (7°C).
- Surface Preparation
Surface should be dry and free of all dirt, oil, laitance and other contaminants. New work should be prepared as follows:
New Wood - Lightly sand and countersink and putty nail heads. Remove all surface contaminants, mold, and mildew which may discolor and inhibit adhesion. Use two coats of AC 301 Exterior Wood Primer over knots, tannin stains, or staining woods such as red cedar.
- Application
Mix Thoroughly Before Use
Airless Spray : Use .013-.017 tip; maintain 1500-2000 psi operating air pressure.
Conventional Spray : Follow instructions of equipment manufacturer for the application of latex paints.
Roll : Use a high quality, short nap synthetic roller cover. Avoid overspreading. Brush—Use a high quality, natural bristle brush.Thinning
Thin as necessary with W-1012 Mineral Spirits or Induron K-1036 Spraying Thinner.
Climate
Use this product only if the substrate temperature and ambient air temperature is above 45°F (7°C) and is expected not to decrease for at least two hours after application. Also, the substrate temperature must be 5°F above the dew point for a period of at least two hours after application to avoid film defects caused from condensation occurring on wet paint.
Properties
- Physical Properties
- Typical Properties
Value | Units | Test Method / Conditions | |
Solids (by Weight) | 61 - 63 | % | - |
Weight | 10 - 10.4 | lbs/gallon | - |
Volatile Organic Contents Mixed Unthinned | 4.0 (465) | lbs/gallon (grams/liter) | - |
Volatile Organic Contents Mixed Thinned | 4.1 (490) | lbs/gallon (grams/liter) | - |
Value | Units | Test Method / Conditions | |
Coverage (Theoretical, at 1.0 mil dry film thickness) | 738.0 | sq. ft/gal | - |
Dry Film Thickness | 1.5 - 2.5 | mils per coat. | - |
Wet Film Thickness | 4.0 - 5.6 | mils | - |
Dry Time to Handle (50°F) | 90.0 | minutes | - |
Dry Time to Recoat (50°F) | 8.0 | hours | - |
Dry Time to Handle (70°F) | 45.0 | minutes | - |
Dry Time to Handle (90°F) | 20.0 | minutes | - |
Dry Time to Recoat (70°F) | 6.0 | hours | - |
Dry Time to Recoat (90°F) | 3.0 | hours | - |