Knowde Enhanced TDS
Identification & Functionality
- Additives Included
- Chemical Family
- Fillers Included
- Polymer Name
- Plastics & Elastomers Functions
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Special Features
Suitable for Low VOC requirements High Flowability
Applications & Uses
- Markets
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications
Daplen EH161AIC is designed for automotive interior parts
Interior Trims Dashboards
Center Consoles Door Panels & Pockets- Low Voc Processing Conditions
To avoid residual humidity from transport or storage, the material should be pre-dried approximately 2h at 80°C.
Following parameters should be used as guidelines:
Holding pressure 50% – 70% of the injection pressure
Injection speed Low to medium
Mold temperature 30 - 50 °C
Injection mass temperature 220 - 260°C
Screw speed Slow to medium- Injection machine barrel must be cleaned carefully during startup to remove possible degraded remains and impurities.
- Shot size is suggested to be kept at 30-70% of machine shot capacity to avoid long material residence time.
- Lower shear rate of plastic material is recommended to achieve lower VOC and odor. Injection speed is recommended to be kept at lower level if part filling is not an issue. Bigger gate size is recommended and try not to use small pin point gate and banana gate.
- Upon successful filling without appearance defect, low barrel temperature is preferred to achieve lower VOC.
- Avoid using mold release or lubricant agent during molding process, which will possibly generate undesirable volatiles and odor.
Properties
- Physical Properties
| Value | Units | Test Method / Conditions | |
| Density | 1000 | kg/m3 | - |
| Melt Flow Rate (230°C/2.16Kg) | 33 | g/10min | - |
| Flexural Modulus (2Mm/Min) | 1700 | MPa | - |
| Tensile Stress At Yield (50Mm/Min) | 19 | MPa | - |
| Charpy Impact Strength, Notched (23°C) | 32 | kJ/m² | - |
| Charpy Impact Strength, Notched (-30°C) | 4 | kJ/m² | - |
| Heat Deflection Temperature B (0.45 N/Mm²) | 98 | °C | - |
| Fogging Gravimetric (100℃,16H) | max. 2.0 | mg | - |
| Emissions | max. 50 | μgC/g | - |
| Mould Average Shrinkage* | 0.75 - 1.00 | % | - |
Regulatory & Compliance
- Recycling
The product is suitable for recycling using modern methods of shredding and cleaning. In-house production waste should be kept clean to facilitate direct recycling.
- Standards
Borouge is certified to various ISO standards.
Safety & Health
- Safety
The product is not classified as a hazardous preparation.
Storage & Handling
- Storage
Daplen EH161AIC should be stored in dry conditions at temperatures below 50°C and protected from UV-light. Improper storage can initiate degradation which results in odor generation and color changes and can have negative effects on the physical properties of this product.