Super WB - SureCrete - Waterborne Coating - Concrete

Identification & Functionality

Chemical Family: Acrylics & Acrylates
Product Type: Sealer,
Waterborne Coating
Technologies: Ready-to-Use Products
Product Families: Ready-to-Use Products — Paints & Coatings
Primers & Sealers

Features & Benefits

Labeling Claims: Environmentally Friendly,
Low VOC,
Non-Flammable,
Wax-free
Ready-to-Use Product Features: Blush Resistant,
Good Adhesion,
High Capacity of Penetration,
High Gloss,
Mechanical Stability,
Water-based
Features: It contains no wax or silicone additives.

The coating is chemical resistant, durable, does not blush, has long solids retention, and is easy to clean.

Super WB is non-flammable and environmentally safe.

Applications & Uses

Markets: Paints & Coatings
Applications: Paints & Coatings — Building & Construction
Concrete Coatings & Stains
Application Method: Spray
Compatible Substrates & Surfaces: Concrete
Coverage: Varies upon substrate: approximately 180 - 200 ft² per gal., per coat 8 - 8.9 mils wet; 1.6 - 1.8 mils cured.
Suitability Sample: Due to condition-specific sites, always prepare an adequate number of test areas.

Wear protection system and esthetic suitability for products’ intended use should be included.

On site sample approval is especially critical on substantial, heavy traffic situation or custom coloration.
Clean Up: Before it dries; spills and tools can be cleaned up with water.
Limitations: Product performs best upon a concrete slab that has no ponding of standing water.

When masking use caution while taping to a floor that is not completely cured, especially at edges, as delamination may occur.

Protect from metal wheel traffic and some furniture where point of contact may be damaging.

Chemicals used in tire manufacturing may be detrimental to all sealers from vehicular parking.
Application Temperature: 50°F - 90°F (10 - 32 °C)

Properties

Regulatory & Compliance

Slip Resistance: Two recognized US agencies have issued directives on minimum coefficient of friction, OSHA (Occupational Safety and Health Administration) and Department of Justice through the ADA (Americans with Disabilities Act).

ADA is the more stringent of the two.

ADA directs that accessible walkways have a minimum coefficient of friction of 0.6.

Ramps have been directed to be 0.8. The applicator assumes the responsibility to meet these standards.

Areas that may become wet, oily, or greasy require special attention.

Technical Details & Test Data

Test Data: QUV Accelerated Weather Testing:

250 hr. - no blistering, no yellowing (ASTM G-53)

Hot Tire Pick-up:

Passed

Under extreme circumstances delaminating could occur.

All tire manufacturers were not tested.

Chemicals used in tire manufacturing may be detrimental to all sealers from vehicular parking.
Chemical Resistance: Testing ASTM D-1308

Transmission fluid Resistant

Gasoline Remove immediately

Formula 409 Resistant

Motor oil Resistant

Brake fluid Remove immediately

Safety & Health

Cautions: Keep out of reach of children.

Product is flammable.

Avoid sources of ignition.

Keep areas ventilated to prevent the accumulation of vapors.

Inhalation:

Use NIOSH approved respirator for organic vapors.

Skin Contact:

Skin contact may cause irritation.

Remove contaminated clothing and wash affected skin with soap and water.

Launder clothing before reuse. If symptoms persist, seek medical attention.

Eyes:

Wear safety eye protection when applying.

If contact occurs, flush eyes with water for 15 minutes, seek medical attention.

Packaging & Availability

Storage & Handling

Shelf Life: Under normal, moisture free conditions 12 months for unopened container.

Super WB™