Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
Applications & Uses
- Markets
- Applications
STEPFACTSP-PE can be used as an anionic emulsifier or dispersant in a variety of agricultural applications, including suspension concentrates and other liquid formulation types.
Properties
- Formulation Type
- Physical Form
- Appearance
- Hazy, yellow liquid (at 25°C)
- Soluble in
- Water, Methanol, Xylene
- Insoluble in
- Kerosene
- Typical Properties
Value | Units | Test Method / Conditions | |
Actives Content | min. 97.5 | % | — |
Average Moles of Ethylene Oxide | 16 | — | — |
Density (at 25°C) | 1.14 | g/ml | — |
Flash Point | min. 94 | °C | PMCC Flash Point Tester |
H₃PO₄ | 2 | % | — |
Moisture Content | 1 | % | — |
pH (in 5% aqueous) | 2 | — | — |
Pour Point | 4 | °C | — |
Viscosity (at 25°C) | 4500 | cPs | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- All components of STEPFAC TSP-PE are listed in the following countries; the registration number for the active ingredient is included in parentheses: United States (TSCA 114535-82-9), Canada (DSL 114535-82-9), Europe (Polymer Exempt), and New Zealand (NZIoC 114535-82-9).
- Approved for use under 40 CFR 180.920; CAS Number 114535-82-9 EPA inerts listing.
- It is the responsibility of the formulator to review the chemical control regulations for each country where the end product is intended to be sold or used.
Safety & Health
- Toxicity
STEPFAC TSP-PE is slightly toxic orally (LD₅₀ > 5000 mg/kg) and it may cause eye irritation.
- Other Data DOT Classification
- Non-Regulated
Packaging & Availability
- Standard Packaging
Available in drums (450 lb, 200 kg) or bulk.
Storage & Handling
- Storage & Handling
- Safety precautions (gloves and safety goggles-face shield, if splashing may occur) should be employed when handling STEPFAC TSP-PE. Avoid contact with eyes and skin should. Wash thoroughly after handling materials.
- Bulk Storage Information: Elevated temperature may be desirable to maintain ease of pumping, but product should be stored long term at ambient temperature.
- STEPFAC TSP-PE that has been stored in drums at temperatures below 50 °F (10 °C) may thicken or solidify. Product may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 130 °F (54 °C) are not recommended.