Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Coating Method
The water-borne coating may be applied best by gravure coating. Spray coating may be used for some special small applications but care must be taken to avoid the electrical pinholes. Water may be used to dilute the coating if necessary.
Drying is best in forced air oven with a temperature of about 350°F. This will yield a dry, colorless, tack-free coating. No primer is required on the metal to achieve good adhesion in most applications. Of course it the metal is soiled or oily then cleaning or priming may be necessary to avoid pinholes.
- Clean Up
Wash the equipment with water to remove the wet adhesive. Dry coating removal will require a toluene solvent wash for best results. Toluene is an inflammable volatile solvent and should be used in conformance of OSHA guidelines.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| VOC per Gallon | 0.94 | % | — |
| Solids by Volume | 30.36 | % | — |
| Solids by Weight | 35.96 | % | — |
| VOC by Volume | 12.89 | % | — |
| VOC by Weight | 10.58 | % | — |
| Water by Volume | 67.07 | % | — |
| Water by Weight | 53.46 | % | — |
| pH | 7.0 - 7.5 | — | — |
| VOC per Gallon Less Water | 2.16 | lb | — |
| Viscosity | 880.0 | cps | — |
| Weight per Gallon | 8.85 | lbs. | — |