Brands

HC™ Heat Cure is a scientifically formulated coating that uses nanotechnology to create a semi-permanent barrier on the surface of a mold which is only 100 nanometers in thickness and facilitates extraordinary plastic or rubber part release. HC coating is designed to be applied when the mold is out of the press.

SYN-LUBE is an extraordinary, state-of-the art synthetic lubricating grease that’s NSF Listed. Food-and medical-grade, the calcium sulfonate formula does not contain metals, PTFE, or silicone. With antioxidants, extreme pressure additives, and anti-wear additives, SYN-LUBE outlasts and outperforms virtually all other greases on the market. PTFE lubricants and other food-grade greases (calcium-based, clay-based, aluminum complex-based) just can’t match the exceptional friction reduction and wear resistance of SYN-LUBE. Designed for the most severe industrial and food applications, SYN-LUBE is the right choice if you’re looking for a universal grease for all of your needs.

Cera-Lube is a high-performance, highly stable lubricant that delivers unmatched performance, durability, and wear resistance. It outlasts PTFE greases in the same applications by ten times due to its lower friction coefficient and its ability to operate in a wider range of temperatures. Cera-Lube has high load-bearing properties; a low dielectric constant; does not contain metal or silicone; and is resistant to water, steam, acids, and most chemical products, giving the lubricant greater longevity, even under intense pressures and temperatures.

QCsi™ Quick Cure Silicone Formula – has been scientifically formulated with the use of nanotechnology to create a semi-permanent barrier on the surface of a mold which is only 100 nanometers in thickness and which facilitates extraordinary silicone part release. QCsi™ is designed to be used on all silicone parts and is applied in the press.

QC™ Quick Cure – has been scientifically formulated with the use of nanotechnology to create a semi-permanent barrier on the surface of a mold which is only 100 nanometers in thickness and which facilitates extraordinary plastic part release. QC coating is designed to be used on all plastics and is applied in the press.