Products

Vertec™ 1024 is PTFE (polytetrafluoroethylene) reinforced with glass fiber. Glass fiber improves the wear properties of PTFE, lowers the deformation under load at both high and low temperatures, and increases the impact resistance while leaving the electrical and chemical characteristics of PTFE essentially unchanged. It is suitable for piston rings, valve seats, shaft seals, electrical insulators, bearing pads and gaskets. This material should not be used in contact with strong alkalis and hydrofluoric acid.

Vertec™ 1011 is a polymer filled PTFE (polytetrafluorethylene) material. It exhibits good sealability, very low coefficient of friction and low wear rate under dry running conditions. Its non-abrasive nature makes it an ideal sealing material for use against soft metal surfaces in dynamic applications. It has been met with great success in high speed, high temperature compressor applications. It is widely used for piston cups and oxygen compressors.

Vertec™ 1006 is a carbon fiber filled PTFE (polytetrafluorethylene) material. It exhibits improved creep and wear resistance. Increased thermal conductivity and low coefficient of friction ensure low wear rate even under dry running conditions. It is suitable for gaskets, valve seals, packings, bearings, and piston rings.

Vertec™ 1009 is a polymer filled PTFE (polytetrafluorethylene) material. It exhibits good sealability, creep resistance, very low coefficient of friction and low wear rate under dry running conditions. Its non-abrasive nature makes it an ideal sealing material for use against soft metal surfaces in dynamic applications. It is suitable for water and steam service, and therefore it is a good candidate where VERTEC 1011 is not acceptable.