Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Highlights
- Asphalt BUR, granulated modified bitumen, smooth modified bitumen and aluminum coated roofs may require ANVIL 9950 2-Part Epoxy Primer for increased adhesion and/or asphalt bleed through resistance.
- On single-ply roofs, 9950 must also be used to increase long term adhesion in areas that retain water.
Applications & Uses
- Application
- Apply only when temperatures are above 50º F and when humidity is below 70% for the next 6 rain free hours.
- Do not thin product.
- Apply at package consistency, do not thin.
- Apply with roller or airless sprayer.
- Airless pump at 7,000 psi rating, delivering 1 to 2 gallon per minute using spray tip of .027-.040. The hose should be at least 1/2” diameter with gun filters removed.
- Allow 2-4 hours between coats.
- Two or three full coats at the rate of 100 sq. ft. per gallon,16 mils WFT, are needed for proper sealing. Apply each coat perpendicular to the last.
Cleanup : Mineral spirits.
- Directions For Use and Surface Preparation
- All surfaces must be clean and free of dirt, dust, rust, mildew and other surface contaminants.
- Remove contaminants by sandblasting, high-pressure water blasting or mechanical methods. Follow appropriate safety guidelines and wear proper protective equipment and clothing.
- Rinse with water and let dry completely.
- Substrate must be dry at time of applying primer and subsequent coating.
Properties
- Typical Properties
- Dry Time and Resin
Dry Time @ 75º F & 50% RH
Drying times are influenced through absorption of moisture from both the substrate and the air.To Touch: 1 to 2 Hours
To Recoat: 2 to 4 HoursResin : 100% Inorganic Silicone with Silane Adhesion Promoters
Value | Units | Test Method / Conditions | |
Weight per Gallon | 11.5 | lbs. | - |
Gloss | Low Sheen | - | - |
VOC Content | 24 - 25 | g/L (cal.) | - |
Tensile Strength | 478.0 | psi | - |
Elongation | 235.0 | % | - |
Tear Strength | 29.0 | lbf/in | - |
Initial Reflectivity | 0.84 | - | - |
Aged Reflectivity | Pending | - | - |
Emissivity | 0.91 | - | - |
Viscosity | 30000.0 | cps | - |
Solid Content by Weight | 98.0 | % | - |
Solid Content by Volume | 97.0 | % | - |
Safety & Health
- Safety Measures
Warning! If you scrape, sand, or remove old paint, you may release lead dust. Lead is toxic. Exposure to lead dust can cause serious illness, such as brain damage. Especially in children. Pregnant women should also avoid exposure. Wear an NIOSH-approved respirator to control lead exposure.
- To avoid breathing vapors and spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying.
- If you experience eye watering, headaches or dizziness, increase fresh air.
- A dust mask does not provide protection against vapors.
- Use only with adequate ventilation.
- Wash thoroughly after handling.
- Clean up carefully with a HEPA vacuum and a wet mop.
- KEEP AWAY FROM CHILDREN.
- KEEP FROM FREEZING
FIRST AID: In case of skin contact, wash thoroughly with soap and water. If any product remains, gently rub petroleum jelly, vegetable or mineral/baby oil onto skin, then wash again with soap and water. Repeated applications may be needed. Remove contaminated clothing. For eye contact, flush immediately with large amounts of water, for at least 15 minutes. If swallowed, get medical attention immediately. If inhalation causes physical discomfort, move to fresh air. If discomfort persists or any breathing difficulty occurs, get medical help.
Precautions
Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/
- Warning! Irritant! Harmful if swallowed.
- Intentional misuse by deliberately concentrating and inhaling the contents may harmful or fatal.
- May cause eye, nose and throat irritation.
- Do not take internally.
- Do not breathe vapors or spray mist.
- Avoid contact with skin and eyes. Wear eye protection and protective clothing.
- For additional safety information, refer to the Safety Data Sheet for this product.
- If properly used, a respirator may offer additional protection. Obtain professional advice before using.
- Close container after each use.
WARNING: This product can expose you to chemicals including Diuron, which is known to the State of California to cause birth defects and reproductive harm. For more information go to www. P65Warnings.ca.gov
WARNING: This product can expose you to chemicals including Titanium Dioxide, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov- Safety Measures
Warning! If you scrape, sand, or remove old paint, you may release lead dust. Lead is toxic. Exposure to lead dust can cause serious illness, such as brain damage. Especially in children. Pregnant women should also avoid exposure. Wear an NIOSH-approved respirator to control lead exposure.
- To avoid breathing vapors and spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying.
- If you experience eye watering, headaches or dizziness, increase fresh air.
- A dust mask does not provide protection against vapors.
- Use only with adequate ventilation.
- Wash thoroughly after handling.
- Clean up carefully with a HEPA vacuum and a wet mop.
- KEEP AWAY FROM CHILDREN.
- KEEP FROM FREEZING
FIRST AID: In case of skin contact, wash thoroughly with soap and water. If any product remains, gently rub petroleum jelly, vegetable or mineral/baby oil onto skin, then wash again with soap and water. Repeated applications may be needed. Remove contaminated clothing. For eye contact, flush immediately with large amounts of water, for at least 15 minutes. If swallowed, get medical attention immediately. If inhalation causes physical discomfort, move to fresh air. If discomfort persists or any breathing difficulty occurs, get medical help.
Precautions
Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/
- Warning! Irritant! Harmful if swallowed.
- Intentional misuse by deliberately concentrating and inhaling the contents may harmful or fatal.
- May cause eye, nose and throat irritation.
- Do not take internally.
- Do not breathe vapors or spray mist.
- Avoid contact with skin and eyes. Wear eye protection and protective clothing.
- For additional safety information, refer to the Safety Data Sheet for this product.
- If properly used, a respirator may offer additional protection. Obtain professional advice before using.
- Close container after each use.
WARNING : This product can expose you to chemicals including Crystaline Silica and Titanium Dioxide, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
Warning
- Hazard statements
- Harmful if swallowed
- May Cause Cancer
- Precautionary statements
- P101 If medical advice is needed, have product container or label at hand.
- P102 Keep out of reach of children.
- P103 Read label before use.
- P280 Wear eye protection / face protection.
- P264 Wash thoroughly after handling.
- P305+P351+P338 If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
- P337+P313 If eye irritation persists: Get medical advice/attention.
Packaging & Availability
- Packaging Type
- Packaging
- Available in 1 gallon cans and 5 gallon buckets.
- Coverage is 100 square feet per gallon, depending on the roof type.
Product No Size UPC Case Size (L x W x H) Case Qty. Pallet Qty. 9900 ROOF-TEC 100% SILICON 5G 990005 5G 760428990054 12” x 12” x 15” 1 36 Cases