Knowde Enhanced TDS
Identification & Functionality
- Base Oil Type
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Non- Silicone Advantages
Silicone-based compounds have an undesirable tendency to physically migrate and contaminate components nearby. This interferes with circuit operation long after hardware installation to cause unexpected, untimely and often inaccessible problems. The AOS Heat Sink Compound’s no creep feature extends circuit life by protecting components longer and by eliminating premature failure of adjacent components caused by migrating silicone base fluid.
- Product Highlights
- AOS Non-Silicone Heat Sink Compound retains all the unique advantages of AOS Heat Sink Compound (Product Code: 52022) with the added benefit of reduced bleed and pump out during use. It is compatible with most metal and plastic components. The product does not contribute to solder bath contamination, and has very low bleed and evaporation. It has a 1-year minimum shelf life in its unopened container. Additional benefits include excellent thermal conductivity and thermal resistance over a wide operating temperature range.
- AOS Non-Silicone Heat Sink Compound is cost effective. The product has greater thermal conductivity than our standard non-silicone thermal grease, but remains comparable in cost. As with our entire line of AOS Heat Sink Compounds, our technical staff can modify AOS Non-Silicone Heat Sink Compound to meet your exacting specifications.
Applications & Uses
- Markets
- Application Area
Properties
- Color
- Physical Form
- Appearance
- Smooth, Gray Paste
- Operating Temperature Range
- -40 to 150
- Typical Properties
- Electrical Properties
| Value | Units | Test Method / Conditions | |
| Bleed (200°C, 24 Hrs, %/Wt) | 0.3 | % | ASTM 6814 |
| Flow Rate (30cc Syringe, 0.08”orifice at 50 PSI, 25°C) | 2 - 5 | g/min | - |
| Specific Gravity (25°C) | 2.7 | - | ASTM D-70 |
| Thermal Conductivity (25°C) | 2.7 | W/m-K | ASTMD 5470-17 |
| Viscosity (1 sec-1) | 700000.0 | cPs | Rheometer |
| Value | Units | Test Method / Conditions | |
| Dielectric Constant (25°C, 1,000 Hz) | 5.0 | - | ASTM D-150 |
| Dielectric Strength (after exposure to 85°C, 85% R.H. for 48 hours) | 212.0 | - | - |
| Dielectric Strength (0.05” gap) | 305.0 | V/mil | ASTM D-149 |
| Dissipation Factor (25°C, 1,000 Hz) | 0.0027 | - | ASTM D-150 |
| Volume Resistivity | 2.15 x 10¹⁵ | ohm-cm | ASTM D-257 |
Regulatory & Compliance
- Certifications & Compliance