Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- CASE Ingredients Functions
- Technologies
- Product Families
Features & Benefits
- CASE Ingredients Features
- Advantages
Low and good colour stability
Low viscosity
Applications & Uses
- Applications
- Compatible Polymers & Resins
- Coating Type
- Applications
Mortar and mastics
Solvent free coating- Processing
Brush, roller or spray coating
Properties
- Physical Form
- Appearance
- Clear liquid
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Color | max. 1 | GS | ASTM D1544 |
| Amine value | 680 - 720 | mg KOH/g | ASTM D2073 |
| Viscosity at 25°C | 5 - 10 | m Pas | ASTM D2196 |
| Pot life at 25°C (Pot life of 100 g mix mass. Mixing ratio with Lapox B-11 (EEW 190) : Lapox AH-313 is 100:12 w/w) | 40 - 50 | Minutes | ASTM D2471 |
| AHEW | 39.5 | g/eq | - |
| Recommended Ratio | 20.8 | w/w | - |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Safety
Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case of direct contact and irritation, the resin should be washed off immediately with soap and warm water. Avoid breathing vapors, mist or gas. Please refer to the SDS for detailed safety instructions.
Packaging & Availability
- Packaging Type
- Packaging
Lapox AH-348 is available in 200 kg MS | HDPE drums and 1,000 kg IBC. Other packing may be considered on request.
Storage & Handling
- Storage & Handling
Lapox AH-348 should be stored in a cool and dry place, preferably in a sealed container and should not be exposed to direct sunlight. This product has a shelf-life of 1 year, if stored in its original container between 18°C and 25°C away from humidity and excessive heat. Please refer to the Safety Data Sheet (SDS) for detailed instructions on storage and handling.
- Spills and disposal
In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable, closed containers for disposal. Soak up with an absorbent such as clay, sand or other suitable material. Flush area with water to remove trace residue. Do not allow the product to reach the sewage system. Waste must be disposed of in accordance with federal, state or local regulations, as applicable.