Knowde Enhanced TDS
Identification & Functionality
- Additives Included
- Chemical Family
- Fillers Included
- Polymer Name
- Plastics & Elastomers Functions
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Special Features
Suitable for Low VOC requirements Good Scratch Resistance
Applications & Uses
- Markets
- Applications
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications
Daplen EF266AIC is designed for automotive interior parts
Dashboard Center Console
Interior Trims- Low Voc Processing Conditions
To avoid residual humidity from transport or storage, the material should be pre-dried approximately 2h at 80°C.
Following parameters should be used as guidelines:
Holding pressure 50% – 70% of the injection pressure
Injection speed Low to medium
Mold temperature 30 - 50 °C
Injection mass temperature 220 - 260°C
Screw speed Slow to medium- Injection machine barrel must be cleaned carefully during startup to remove possible degraded remains and impurities.
- Shot size is suggested to be kept at 30-70% of machine shot capacity to avoid long material residence time.
- Lower shear rate of plastic material is recommended to achieve lower VOC and odor. Injection speed is recommended to be kept at lower level if part filling is not an issue. Bigger gate size is recommended and try not to use small pin point gate and banana gate.
- Upon successful filling without appearance defect, low barrel temperature is preferred to achieve lower VOC.
- Avoid using mold release or lubricant agent during molding process, which will possibly generate undesirable volatiles and odor.
Properties
- Physical Properties
Value | Units | Test Method / Conditions | |
Density | 1040 | kg/m3 | ISO 1183 |
Melt Flow Rate (230°C/2.16Kg) | 20 | g/10min | ISO 1133 |
Flexural Modulus (2Mm/Min) | 2300 | MPa | ISO 178 |
Tensile Stress At Yield (50Mm/Min) | 26 | MPa | ISO 527-2 |
Charpy Impact Strength, Notched (23°C) | 4.5 | kJ/m² | ISO 179/1eA |
Charpy Impact Strength, Notched (-30°C) | 2 | kJ/m² | ISO 179/1eA |
Heat Deflection Temperature B (0.45 N/Mm²) | 110 | °C | ISO 75-2 |
Fogging Gravimetric (100℃,16H) | max. 2.0 | mg | DIN 75201 |
Emissions | max. 50 | μgC/g | VDA 277 |
Mould Average Shrinkage* | 1.1 - 1.3 | % | Borouge Method |
Regulatory & Compliance
- Recycling
The product is suitable for recycling using modern methods of shredding and cleaning. In-house production waste should be kept clean to facilitate direct recycling.
- Standards
Borouge is certified to various ISO standards.
Safety & Health
- Safety
The product is not classified as a hazardous preparation.
Storage & Handling
- Storage
Daplen EF266AIC should be stored in dry conditions at temperatures below 50°C and protected from UV-light. Improper storage can initiate degradation which results in odor generation and color changes and can have negative effects on the physical properties of this product.