Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Fillers Included
- Polymer Name
- Plastics & Elastomers Functions
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Special Features
Suitable for Low VOC requirements - High Flowability
Applications & Uses
- Markets
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications & Uses
Daplen EH162AIC is designed for automotive interior parts
Interior Trims - Dashboards
Center Consoles - Door Panels & Pockets- Processing Conditions
The actual conditions will depend on the type of equipment used.
This product is easy to process with standard injection molding machines. To avoid residual humidity from transport or storage, the material should be pre-dried approximately 2h at 80°C.
Following parameters should be used as guidelines:Holding pressure 50% - 70% of the injection pressure
Mold temperature 30 - 50°C
Injection mass temperature 220 - 260°C
Injection speed Low to mediumScrew speed Slow to medium
Specific recommendations for processing conditions can be determined only when the application and type of equipment are known. Please contact your local Borouge representative for such particulars.
Properties
- Physical Properties
Value | Units | Test Method / Conditions | |
Density | 1000 | kg/m3 | - |
Melt Flow Rate (230°C/2.16Kg) | 33 | g/10min | - |
Flexural Modulus (2Mm/Min) | 1700 | MPa | - |
Tensile Stress At Yield (50Mm/Min) | 19 | MPa | - |
Charpy Impact Strength, Notched (23°C) | 32 | kJ/m² | - |
Charpy Impact Strength, Notched (-30°C) | 4 | kJ/m² | - |
Heat Deflection Temperature A (1.8 N/Mm²) | 98 | °C | - |
Fogging Gravimetric (100℃,16H) | max. 2.0 | mg | - |
Emissions | max. 50 | μgC/g | - |
Mould Average Shrinkage* | 0.75 - 1.00 | % | - |
Regulatory & Compliance
- Recycling
The product is suitable for recycling using modern methods of shredding and cleaning. In-house production waste should be kept clean to facilitate direct recycling.
- Standards
Borouge is certified to various ISO standards.
Safety & Health
- Safety
The product is not classified as a hazardous preparation.
Storage & Handling
- Storage
Daplen EH162AIC should be stored in dry conditions at temperatures below 50°C and protected from UV-light. Improper storage can initiate degradation which results in odor generation and color changes and can have negative effects on the physical properties of this product.