Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Requisits For Application
- The foundations to receive the floor covering must be flat and with a smooth surface, suitable for obtaining a continuous adhesive film of the adhesive. It must be clean, free of loose granules or dust (plaster, oils, paints, etc.) to ensure good adhesion.
- The foundations must also, in accordance with DIN 18365:
- Resist without deformation, cracking or rupture to loads arising from normal conditions of use, capable of affecting both the coating and the respective bonding plane.
- Present absorption that guarantees good adhesion of the smoothing masses or glues. The maximum permissible moisture content is 2.5%, and the coating shall not be exposed to moisture in any way.
- The cleaning of tools should be carried out with water while the glue film is fresh, with a dilutant after drying. In case of adhesive stains on the covering, clean immediately with a damp cloth.
- Application Method
- Apply the adhesive with an A1 trowel or foam roller preferably on the back of the covering in order to allow the coated surface to be used when removing the covering.
- Wait until the glue film becomes transparent. Absorbent surfaces: 20 to 30 minutes and non-absorbent 40 to 50 minutes, at an ambient temperature of 20ºC and relative humidity of 55%.
- In lower temperatures and higher relative humidities prolong this waiting time. Then fix the covering by pressing lightly.
- Coatings with little intrinsic resistance should be removed slowly and if necessary, with the help of a spatula.
Properties
- Color
- Physical Form
- Characteristics
| Value | Units | Test Method / Conditions | |
| Viscosity (Brookfield RVTD-Spindle 3, 20 rpm, 20°C) | 800 - 1600 | cPs | ME 006 |
| Solids Content | 65 - 70 | % | ME 007 |
| Density | 1.00 - 1.10 | g/cm³ | ME 009 |
| pH | 3.5 - 6 | — | ME 018 |
| Yield (Foam Roller) | 100 | g/m² | — |
| Yield (A1 Trowel) | 150 - 180 | g/m² | — |
| Waiting Time (Absorbent Base) | 20 - 30 | minutes | — |
| Waiting Time (Non-absobent Base) | 40 - 50 | minutes | — |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Packaging Information
125 Kg
Storage & Handling
- Shelf Life
- 8 Months
- Storage Information
This product must be stored in a well-ventilated place, in its original packaging, well closed, protected from moisture and sunlight, and at temperatures between 15ºC and 25ºC. Under these conditions the product is valid for 8 months.