company tower banner
DayGlo Company Logo

DayGlo Horizon Blue Acrylic Latex Paint (SRX-19)

Screamin' SRX Fluorescent Paint is a premium, low odor, water-based fluorescent latex paint. Maximum lightfastness and film integrity are dependent upon the use of DayGlo FILTERAY® Type "W" (clear overcoat). DayGlo® Screamin' SRX paints appear to glow in the dark when exposed to black light.

Product Type: Waterborne Coating

Features: Good Light Fastness, Low Odor, Water-based

Application Method: Brush

Chemical Family: Acrylics, Acrylates & Methacrylates

  • TypeDocument Name
View All Documents

Knowde Enhanced TDS

Identification & Functionality

Product Type

Features & Benefits

Ready-to-Use Product Features
Features
  • Formaldehyde-free formulation
  • Low odor
  • Environmentally friendly
  • 100% acrylic latex
  • Available in 7 brilliant fluorescent colors and Filteray W clear overcoat
  • Available in 1 pint and 1 gallon containers

Applications & Uses

Application Method
General Application Instructions

Undercoat:
DayGlo SRX latex paints are semi-transparent and, therefore, brightest when applied over a clean, white surface. White semi-gloss latex coatings, flat white latex undercoaters, water based primersealers and water-based bulletin blockout whites are ideally suited for this purpose. Over old finishes, clean and sand before applying a white undercoat or primer that offers good adhesion to both the old finish and new DayGlo paint. However, best performance can be achieved by removing old finishes and starting with a freshly primed surface.

SRX Latex Paint Color Coat:

  • Stir well and if thinning is necessary, use water. (AVOID OVER THINNING).
  • Apply one heavy coat of DayGlo SRX latex paint with a soft brush. Use short strokes. Cover completely and smooth out as you go to produce a uniform deep layer (approximately 1.5 mils thick dry). Keep in mind that thin spots or streaks will fade prematurely. Allow to set-up or "top dry" at least 10 minutes (@ 70oF).
  • Apply the second coat same as the first. Allow 3 hours to dry before applying DayGlo SRX Filteray W overcoat.
  • For sign applications, the DayGlo SRX coat can simply be roughed in, slightly overlapping the copy line. Your copy line will not be hidden because DayGlo SCR paint is semitransparent. Do not try to work the paint exactly to a line. An opaque background should be used to cut in accurately to the copy line for sharp detail after the DayGlo SRX paint has top dried 24 hours.

Properties

Typical Properties
ValueUnitsTest Method / Conditions
Grindmin. 5Hegman gauge
Viscosity (at 77ºF)1,500 - 2,500cPs
pH Value8.00 - 9.00

Regulatory & Compliance

Chemical Inventories