Personal Hygiene Cleanser

Formulation

Name	Ingredient	Supplier	%
Phase A
DEIONIZED WATER		—	32.06
LACTIC ACID (80%) LACTIC ACID	LACTIC ACID	—	0.80
L-ARGININE ARGININE	ARGININE	—	0.90
ALLANTOIN ALLANTOIN	ALLANTOIN	—	0.09
BETAINE BETAINE	BETAINE	—	1.80
SORBITOLO LGK (70%) SORBITOL	SORBITOL	—	9.00
XYLISORB 300 XYLITOL	XYLITOL	—	0.40
COMIXAN ST/HV XANTHAN GUM	XANTHAN GUM	—	0.40
ARISTOFLEX AVC AMMONIUM ACRYLOYLDIMETHYLTAURATE / VP COPOLYMER	AMMONIUM ACRYLOYLDIMETHYLTAURATE / VP COPOLYMER	—	0.30
Phase C
OXINEX ST LIQUID DIETHYLHEXYL SYRINGYLIDENEMALONATE	DIETHYLHEXYL SYRINGYLIDENEMALONATE	—	0.10
Phase B
TOCOPHERYL ACETATE TOCOPHERYL ACETATE	TOCOPHERYL ACETATE	—	1.80
SAGE GLYCOLIC EXTRACT SALVIA OFFICINALIS EXTRACT + PROPYLENE GLYCOL	SALVIA OFFICINALIS EXTRACT + PROPYLENE GLYCOL	—	1.00
PHENOXYETHANOL PHENOXYETHANOL	PHENOXYETHANOL	—	0.80
PHENYLETHYL ALCOHOL PHENYLETHYL ALCOHOL	PHENYLETHYL ALCOHOL	—	0.10
Phase E
DEIONIZED WATER		—	2.00
SODIUM BENZOATE SODIUM BENZOATE	SODIUM BENZOATE	—	0.25
NATRLQUEST E 30 TRISODIUMETHYLENEDIAMINE DISUCCINATE	TRISODIUMETHYLENEDIAMINE DISUCCINATE	—	0.20
ANDEAN QD ULTRA (25%Aq.Sol) QUILLAJA SAPONARIA EXTRACT + AQUA	QUILLAJA SAPONARIA EXTRACT + AQUA	—	8.00
Phase D
DEIONIZED WATER		—	40.00
VEEGUM HV SODIUM ALUMINUM SILICATE	SODIUM ALUMINUM SILICATE	—	2.00

Preliminary phases:

Prepare a 25% solution of Andean QD Ultra in deionised water under cupboard.
Phase B: Mix the ingredients until clear solution.
Phase D: Add Veegum HV to water and heat to 80°C while homogenizing with turbine and blades. At this temperature homogenize for 10’ and then start to cool to room temperature while mixing with blades.
Phase E: Mix the ingredients until clear solution.

Addition scheme:

In main mixer add ingredients A and mix until clear solution after each addition. Then add A1 and homogenize for 5’; then heat the phase to 40°C and at this temperature homogenize the phase for 5’.
Add A2 and homogenize for 10’. Check homogeneity.
Add phase B and homogenize with turbine and blades under vacuum for 5’.
Add C and homogenize with turbine and blades under vacuum for 5’.
Add phase D and homogenize with turbine and blades under vacuum for 5’.
Add phase E and mix with blades for 5’. Take a sample for analytical controls.