Design Polymerics 2500 Water Based Duct Linear Adhesive

Knowde Enhanced TDS

Identification & Functionality

Carrier: Water
Chemical Family: Synthetic Rubbers
Product Type: Waterborne Adhesive
Technologies: Ready-to-Use Products
Product Families: Ready-to-Use Products — Adhesives & Sealants
Other Adhesives & Sealants
Identification: Base: Water
Chemical Family: Synthetic Latex

Features & Benefits

Labeling Claims: Low VOC,
Non-Flammable
Ready-to-Use Product Features: Consistent High Quality,
Low Odor,
Low VOC,
Moisture Resistant,
Oxidation Resistant,
UL Listed,
UV Resistant,
Water Resistant
Features & Benefits: LEED V4 Qualified

UL Classified

Meets FDA, USDA, and EPA Standards

Meets CDPH Emission Requirements

Formulated to meet the requirements of ASTM E-84,

NFPA 90A & 90B and ASTM C-916, Type II

Excellent Wet Tack

Non-Flammable

Moisture Resistant

Exceptional Coverage

Low Odor

Non-Oxidizing

Applications & Uses

Markets: Adhesives & Sealants,
Building & Construction
Applications: Building & Construction — Building Materials
Construction Adhesives,
Pipes & Plumbing
Adhesives & Sealants — Other Adhesives & Sealants Applications
Application Area: Pipe Liners
Application Method: Brush,
Roller,
Spray
Compatible Substrates & Surfaces: Fiberglass
Recommended Uses: Bonding fibrous duct wrap and duct liner insulation to galvanized ductwork.
Sealing cut edges of fiberglass insulation.
Bonding kraft backed foil coverings to fiberglass and urethane flat stock or pipe insulation.
Bonding multiple layers of fibrous inslulation board.
Directions for Use: Surface Preparation:

Surfaces should be clean, dry and free of dirt, oil and any foreign matter.

Application:

DP 2500 may be applied by brush, roller, roller coater, or spray equipment. DP 2500 may be applied to either the galvanized steel or the fibrous insulation.

For internal fiberglass duct insulation:

Apply DP 2500 evenly and secure with mechanical fasteners in accordance with SMACNA standards. DP 2500 should be applied at temperatures above 40°F and below 110°F, and should never be exposed to temperatures that exceed 200°F or fall below -25°F. Do not thin.

Properties

	Value	Units	Test Method / Conditions
Application Temperature	40 - 110	°F	-
Coverage (Dependent on Application Thickness, 20-40 Wet Miils)	400.0	sq. ft.	-
Flammability	Non-flammable Wet or Dry	-	-
Flash Point	No Flash to Boiling	°F	-
Freeze/Thaw Stability	Do not allow to freeze	-	-
Open Time (depending on humidity, temperature, and application rate)	10 - 20	Minutes	-
Service Temperature	-25 to 200	°F	-
Solids Content	28 - 32	%	-
Storage Temperature	40 - 110	°F	-
Viscosity	2000 - 3000	Cps	-
VOC	4.0	g/l	-

Regulatory & Compliance

Certifications & Compliance: EPA Registered,
FDA Compliant,
LEED (Leadership in Energy & Environmental Design),
National Fire Prevention Association (NFPA),
USDA Certified

Packaging & Availability

Storage & Handling