Knowde Enhanced TDS
Identification & Functionality+
Fatty Alcohols - 65.0%
Octanol (C8) – 27.8%
Decanol (C10) – 37.0%
Related Compounds (Dodecanol – C12) – 0.2%
Flumetralin - 3.2%
OTHER INGREDIENT - 31.8%
Features & Benefits+
PLUCKER-PLUS is a plant growth regulator with a carefully balanced combination of active ingredients and wetting agents (surfactants) to be used for the control of sucker growth on Burley, Flue-cured and Dark tobacco. The concentrated product is diluted with water to form a creamy emulsion which is applied as a coarse spray. The emulsion is effective when it comes in direct contact with suckers; therefore, the material should be applied so that maximum contact is made with all Tobacco suckers. This product can be used alone or with Maleic hydrazide (MH) such as Super Sucker-Stuff®, Sucker-Stuff® and Sucker-Stuff® 80EG in a dual treatment program.
Applications & Uses+
USER SAFETY RECOMMENDATIONS
Users should: 1) Wash hands before eating, drinking, chewing gum, using tobacco or using the toilet.
2) Remove clothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing.
3) Remove PPE immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into clean clothing.
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your state or tribe, consult the agency responsible for pesticide protection.
This label must be in the possession of the user at the time of pesticide application. Observe all precautions and restrictions in this label and the labels of products used in combination with this product. The use of this product not consistent with this label can result in injury to crops, animals or persons.
Do not allow spray to drift from the application site and contact people, structures people occupy at any time and the associated property, parks and recreation areas, non-target crops, aquatic and wetland areas, woodlands, pastures, rangelands or animals.Do not enter or allow other people (or pets) to enter the treated area until sprays have dried.
Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part 170. This standard con-tains requirements for the protection of agricultural workers on farms, forests, nurseries, greenhouses and handlers of agricultural pesticides. It contains requirements for training, decontamination, notification and emergency assistance. It also contains specific instructions and exceptions pertaining to the statements on this label about Personal Protective Equipment (PPE) and Restricted Entry Interval (REI). The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard.
Do not enter or allow worker entry into treated areas during the restricted entry interval of 48 hours. For greenhouse uses, do not enter or allow worker entry into treated areas during the REI of 24 hours.
For at least seven days following the application of Copper-contain-ing products in greenhouses:
• at least one container or station designed specifically for flushing eyes is available in operating condition with the WPS-required decontamination supplies for workers entering the area treated with Copper-containing products,
• workers are informed orally, in a manner they can understand:
– that residues in the treated area may be highly irritating to their eyes,
– that they should take precautions, such as refraining from rub-bing their eyes, to keep the residues out of their eyes,
– that if they do get residues in their eyes, they should immedi-ately flush their eyes with the eye flush container that is located with the decontamination supplies and
– how to operate the eye flush container or eye flush station.
PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with any-thing that has been treated, such as plants, soil or water is: Coveralls, chemical-resistant gloves made of any waterproof material, shoes plus socks and protective eyewear.
The diluted emulsion is most easily prepared by adding the required amount of this product to your spray tank one-half filled with water using mild agitation and then adding water for the required minimum solution. In order to obtain best results, it is important that the product always be added to water.
In order to minimize the possibility of injury to the Tobacco plants, do not mix this product with other chemicals such as insecticides, fungicides or herbicides or apply this product to plants which have recently been treated with such chemicals.
Safety & Health+
Hazards to Humans and Domestic Animals
CAUTION: Harmful if absorbed through skin. Harmful if swallowed. Causes moderate eye irritation. Avoid contact with skin, eyes or clothing.
PERSONAL PROTECTIVE EQUIPMENT (PPE)
Some materials that are chemical-resistant to this product are listed below. If you want more options, follow the instructions for Category G on an EPA chemical-resistance category selection chart.
Applicators and other handlers must wear: Long-sleeved shirt and long pants, socks, shoes and chemical-resistant gloves such as barrier laminate or viton, chemical-resistant headgear for overhead exposure and chemical-resistant apron when cleaning equipment, mixing or loading.
Follow manufacturer’s instructions for cleaning/maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry.
Discard clothing and other absorbent materials that have been drenched or heavily contaminated with this product’s concentrate. Do not reuse them.
This product is toxic to fish. Do not apply directly to water or to areas where surface water is present or to intertidal areas below the mean high water mark. Drift or runoff from treated areas may be hazardous to aquatic organisms in adjacent aquatic sites. Do not contaminate water when disposing of equipment washwater or rinsate.
Packaging & Availability+
Storage & Handling+
Do not contaminate water, food or feed by storage or disposal.
PESTICIDE STORAGE: Store in original container in secured dry storage area. Prevent cross-contamination with other pesticides and fertilizers. Do not store above 100ºF for extended periods of time. Storage below 20ºF may result in formation of crystals. If product crystallizes, store at 50ºF to 70ºF and agitate to re-dissolve crystals. If container is damaged or spill occurs, use product immediately or dispose of product and damaged container as indicated below.
PESTICIDE DISPOSAL: Pesticide wastes are toxic. Improper disposal of excess pesticide, spray mixture or rinsate is a violation of Federal law. If these wastes cannot be disposed of by use according to label instructions, contact your State Pesticide or Environmental Control Agency or the Hazardous Waste Representative at the nearest EPA Regional Office for guidance.
Nonrefillable Container (rigid material; < 5 gallons): Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available. Triple rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container one-fourth full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Then offer for recycling if available or puncture and dispose of in a sanitary landfill or by incineration.
Nonrefillable Container (rigid material; > 5 gallons up to < 250 gallons): Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available. Triple rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container one-fourth full with water. Replace and tighten closures. Tip container on its side and roll it back and forth, ensuring at least one complete revolution, for 30 seconds. Stand the container on its end and tip it back and forth several times. Turn the container over onto its other end and tip it back and forth several times. Empty the rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Repeat this procedure two more times. Then offer for recycling if available or puncture and dispose of in a sanitary landfill, or by incineration.
Refillable Container (≥ 250 gallons & Bulk): Refillable container. Refill this container with pesticide only. Do not reuse this container for any other purpose. Cleaning the container before final disposal is the responsibility of the person disposing of the container. Cleaning before refilling is the responsibility of the refiller. To clean the container before final disposal, empty the remaining contents from this container into application equipment or mix tank. Fill the container about 10% full with water. Agitate vigorously or recirculate water with the pump for 2 minutes. Pour or pump rinsate into application equipment or rinsate collection system. Repeat this rinsing procedure two more times. Then offer for recycling if available or puncture and dispose of in a sanitary landfill, or by incineration or by other procedures approved by state and local authorities.