Products

Enflon® 102 is 10% glass fiber. Milled glass fibers have the least effect on chemical and electrical properties and add greatly to the mechanical properties of unfilled PTFE. The addition of glass improves compressive properties by as much as 40% and improves wear resistance greatly. These compounds resist acids and oxidation, but can be attacked by alkalis.

Enflon® 131 is 10% carbon. Carbon has good chemical resistance to corrosive environments. It exhibits good initial wear and rubbing or sliding contact characteristics, both dry and water applications. It is frequently used in piston rings to reduce cylinder wall wear by entrapping abrasive foreign particles in their relatively soft surfaces.

Enflon® 130 is 5% carbon. Carbon has good chemical resistance to corrosive environments. It exhibits good initial wear and rubbing or sliding contact characteristics, both dry and water applications. It is frequently used in piston rings to reduce cylinder wall wear by entrapping abrasive foreign particles in their relatively soft surfaces.

Enflon® 166 is maroon in color, this material provides high wear resistance and low friction in a continuous, non-lubricated service. Good dielectric and insulation properties. Excellent choice for bearings, gaskets and high pressure applications requiring robust components. Alternative to Rulon® LR.

Virgin Super Modified PTFE is weldable and has lower deformation under load.

Enflon® 101 is 5% glass fiber. Milled glass fibers have the least effect on chemical and electrical properties and add greatly to the mechanical properties of unfilled PTFE. The addition of glass improves compressive properties by as much as 40% and improves wear resistance greatly. These compounds resist acids and oxidation, but can be attacked by alkalis.

Enflon® 168 is gold in color, this material is used for low abrasion and used against soft surfaces. Low coefficient of friction and designed to run dry without lubrication. Alternative to Rulon® J.

Enflon® 110 is 5% graphite. Graphite offers improved chemical resistance to corrosive environments and exhibits good initial wear and rubbing/sliding characteristics in dry and water applications. Graphite is commonly blended with carbon and PTFE.

Enflon® 115 is 25% bronze. This filler has better wear, creep resistance, and higher thermal conductivity than glass fiber with PTFE. The compound is easily machined, but has poor chemical resistance in the presence of acids and alkali. Useful in applications which undergo high mechanical loads or high-speed rubbing contacts where the bronze filler supplies the strength and conductivity to carry away excess, unwanted heat.

Enflon® 111 is 10% graphite. Graphite offers improved chemical resistance to corrosive environments and exhibits good initial wear and rubbing/sliding characteristics in dry and water applications. Graphite is commonly blended with carbon and PTFE.

Virgin PTFE provides a low-friction, non-stick surface suitable for use in high-temperature and high-dielectric applications. PTFE Film and PTFE Sheets are available in roll form or cut to size sheets and can be supplied etched one-side, etched two-side or with a self-adhesive acrylic backing (pressure-sensitive tape).

Enflon® 127 is 5% molybdenum disulfide. This filler is used frequently in combination with others to increase surface hardness, stiffness, and to reduce the starting coefficient of friction and steady-state wear. Its effect on electrical and chemical properties is negligible.