Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Product Modification
Product code nomenclature takes in to account selected primary features of a product. The suffix may indicate a primary additional functionality, however, further multiple modifications are almost always possible and may be agreed upon and specified prior to our technical and commercial offer. Such enhancements are a normal part of our service capability and they do not affect the general characteristics listed in technical datasheets.
Applications & Uses
- Markets
- Applications
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Drying
Space must be left between sheets to allow correct drying.
Properties
- Physical Form
- Mechanical Properties
- Typical Properties
- Thermal Properties
- Miscellaneous Properties
- Notes
Unless otherwise stated, products are tested at a typical thickness of 4mm
1 The impact values stated indicate the range that this grade meets and depends on thickness of the sheet, plus actual material grades selected in each layer for every customer’s project – typically customized. Mechanical suitability for each formulation should be evaluated based on the material delivered.
* The density quoted should only be used as a guide. This value can change depending upon the type and quantity of pigments or additives used.
** Fire behavior values given by raw material supplier or by indicative test on raw material. Not intended as a specification.
Value | Units | Test Method / Conditions | |
Tensile Modulus (23°C) | 1900.0 | MPa | ISO 527 |
Yield Stress (23°C) | 28.0 | MPa | ISO 527 |
Elongation at Break (23°C) | 12.0 | % | ISO 527 |
Charpy (Notched, 23°C, 1eA) | 20 - 251 | KJ/m² | ISO 179 |
Charpy (Un-Notched, 23°C, 1eU) | NB | KJ/m² | ISO 179 |
Cross-Bending Stress | 65.0 | N/mm² | DIN 53452 |
Value | Units | Test Method / Conditions | |
Density* | 1.06 | g/cm³ | ISO 1183 |
UV Stabilisation (According to Customer Requirement) | Optional | — | — |
Value | Units | Test Method / Conditions | |
VICAT Softening Point (A/50) | 93.0 | °C | ISO 306 |
HDT-A (A 1.8MPa) | 97.0 | °C | ISO 75 |
Value | Units | Test Method / Conditions | |
Mould Shrinkage | 0.5 - 0.7 | % | — |
Thermoforming Temperature | 180 - 210 | °C | — |
Technical Details & Test Data
- Supplemental Information
Chemical Contact and cleaning
Reagent Chemical resistanceReagent Chemical resistanceAcetone Not recommendedBrake Fluid Not RecommendedAcid – (Weak) Excellent Butter Excellent Acid – (Strong) Good Coffee Excellent Alcohol Good/Fair Detergent Excellent Anti-freeze Excellent Diesel Good Base (Weak) Excellent Foodstuffs Good Base (Strong) Good Lubricating Oil Very Good Battery acid Good Petrol Good This product exhibits a higher chemical resistance versus ABS according to ISO 22088 point 3.
Chemical resistance is influenced by many factors, including concentration, temperature, exposure time and material stress. Therefore the data should only be used as a guide.
Most common mild soaps or detergents dissolved in warm water can be used to effectively clean general dirt and surface contaminants, but in all cases should be objectively tested. Abrasive products will damage the surface.- Dimensional Tolerances
Standard tolerances are subject to the local standard tolerance set. Extra tolerance requirements may be possible on request and by special agreement
Storage & Handling
- Storage
Long storage times in humid conditions may require a product to be dried, e.g. 80oC for 2 hours +1hr per additional mm of thickness.