Knowde Enhanced TDS
Identification & Functionality
- Polymer Name
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Materials Features
- Product Modification
Product code nomenclature takes in to account selected primary features of a product. The suffix may indicate a primary additional functionality, however, further multiple modifications are almost always possible and may be agreed upon and specified prior to our technical and commercial offer. Such enhancements are a normal part of our service capability and they do not affect the general characteristics listed in technical datasheets.
Applications & Uses
- Markets
- Applications
- Plastics & Elastomers End Uses
- Drying
Space must be left between sheets to allow correct drying.
Properties
- Physical Form
- Mechanical Properties
- Typical Properties
- Thermal Properties
- Miscellaneous Properties
- Notes
Unless otherwise stated, products are tested at a typical thickness of 4mm
* The density quoted should only be used as a guide. This value can change depending upon the type and quantity of pigments or additives used.
** Fire behavior values given by raw material supplier or by indicative test on raw material. Not intended as a specification
Value | Units | Test Method / Conditions | |
Tensile Modulus (23°C) | 2300.0 | MPa | ISO 527 |
Yield Stress (23°C) | 50.0 | MPa | ISO 527 |
Elongation at Break (23°C) | 50.0 | % | ISO 527 |
Charpy (Notched, 23°C, 1eA) | 24.0 | KJ/m² | ISO 179 |
Charpy (Notched, -30°C, 1eA) | 10.0 | KJ/m² | ISO 179 |
Value | Units | Test Method / Conditions | |
Density* | 1.13 | g/cm³ | ISO 1183 |
UV Stabilisation (According to Customer Requirement) | Optional | — | — |
Value | Units | Test Method / Conditions | |
VICAT Softening Point (B/50) | 118.0 | °C | ISO 306 |
HDT-A (A 1.8MPa) | 102.0 | °C | ISO 75 |
Value | Units | Test Method / Conditions | |
Mould Shrinkage | 0.5 - 0.7 | % | — |
Thermoforming Temperature | 180 - 210 | °C | — |
Technical Details & Test Data
- Supplemental Information
Chemical Contact and cleaning
Chemical resistance is influenced by many factors, including concentration, temperature, exposure time and material stress. Please contact our technical team for more information.
Most common mild soaps dissolved in warm water can be used to effectively clean general dirt and surface contaminants, but in all cases should be objectively tested. Abrasive products will damage the surface.- Dimensional Tolerances
Standard tolerances are subject to the local standard tolerance set. Extra tolerance requirements may be possible on request and by special agreement
Storage & Handling
- Storage
Long storage times in humid conditions may require a product to be dried, e.g. 80oC for 2 hours +1hr per additional mm of thickness.