Honey Wax®

Identification & Functionality

Plastics & Elastomers Functions

Mold Release Agent,

Release Agent

Technologies

Elastomers,

Plastics

Product Families

Elastomers — Elastomer Additives

Performance Additives

Plastics — Polymer Additives

Performance Additives

Features & Benefits

Materials Features

Abrasion Resistant,

Durable,

Good Adhesion,

Good Stain Resistance,

High Gloss

Applications & Uses

Markets

Adhesives & Sealants,

Automotive & Transportation,

Building & Construction,

Printing & Packaging

Applications

Building & Construction — Building Materials

Interior Fixtures

Adhesives & Sealants — Packaging & Paper

Flexible Packaging Adhesives

Printing & Packaging — Tapes, Labels & Adhesives

Flexible Packaging Adhesives

Automotive & Transportation — Transportation

Marine

Composites End Use

FRP Boats

Plastics & Elastomers End Uses

Release Film

Mold Preparation

• It is essential that the mold surface be thoroughly cleaned so that all traces of previous waxes used and/or other release agents or any foreign materials are removed. KantStik® Mold Cleaner will remove waxes and wax residue. It should be noted, however, that the Kantstik® Mold Cleaner breaks down the wax and, therefore, residue must be removed from the mold surface. A clean cloth should be used for this purpose to ensure that the dissolved wax is completely removed and not merely being spread.
• Continue the process until the surface is completely clean. To test the surface for cleanliness, use a piece of masking tape on various points on the mold surface. Good adhesion to the mold should be observed when removing tape. If not, further cleaning is necessary.

Applications

Once the mold surface has been thoroughly cleaned, Honey Wax® can be applied using a soft cotton cloth, being careful not to scratch the fiberglass mold surface.

• Apply a thin, even film of Honey Wax® using circular motions and making sure there is complete uniform coverage.
• The coating should be left to haze completely. This process should take approximately 15 minutes depending upon ambient temperatures and humidity. Hazing is an important step, as all the carriers (mineral spirits) should evaporate completely before buffing. The wax film should be totally dry.
• Buff the surface to a luster using a fresh, clean absorbent cloth.
• Wait approximately 10 to 15 minutes before applying another coat of Honey Wax®. Five to seven applications initially will effectively fill the pores and coat the mold surface (The number of coats depends upon the porosity of the mold).
• Once a part is pulled, apply two more coats of Honey Wax® following Steps 1, 2 and 3.
• For the third part, a single application will suffice. From this point on, multiple pulls can be achieved.

Properties

Physical Form

Solid,

Wax

Packaging & Availability

Availabilty

Honey Wax® is available in 14-ounce cans, 12 cans per case

Storage & Handling

Storage

Reseal the lid tightly when not in use to avoid solvent evaporation and loss in performance. For more information, please refer to our Material Safety Data Sheet.