Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Agrochemical Functions
- Technologies
- Product Families
- Composition
- PRINCIPAL FUNCTIONING AGENTS:
- Polyvinyl Polymer (Polyacrylamide) .. - 35.25%
- Constituents ineffective as adjuvants - 64.25%
- TOTAL - 100.00%
Features & Benefits
- Agrochemicals Features
- Product Highlights
- Compatible with a wide range of spray equipmentResistant to pump shearWorks with all nozzle types
- Resistant to pump shear
- Works with all nozzle types
- General Information
- POINTBLANK® WM is an effective, easy-to-use adjuvant for deposition improvement and drift retardation in spraying operations. POINTBLANK® WM is designed for general use in standard ground and aerial applications and is fully compatible with a wide variety of spray configurations including those with new A.I. and other specialized drift reduction nozzles. Further, POINTBLANK® WM is compatible in tank mix application with a broad spectrum of crop protection pesticides, including the complete range of all branded and generic glyphosate formulations
Applications & Uses
- Markets
- Applications
- Applicable Crop
- Application Technique
- Directions for Use
- Dosages may be adjusted to compensate for environmental conditions or mechanical factors. Lower dosages may be used when spraying under calm winds, slow application speeds, low pressures, and lower boom heights with nozzles closer to the target. The greater the shear on the spray boom nozzle head, the greater the spray droplet fragmentation, which produces fines (mists) that may drift to non-targeted areas or evaporate. For best results in aerial application, use state-of-the-art techniques, such as pressure less than 45 psi and nozzles oriented 45 degrees back to straight back.
- Mixing Guidelines
POINTBLANK® WM is very concentrated and performs effectively at ultra low use rates even as low as 1-4 oz. per 100 gal. of water. Start with low dosage rates and increase as needed. A thickened or “stringy” solution indicates that too much POINTBLANK® WM has been used.
- Step 1.Select proper dosage for the spraying operation.
- Step 2.Fill mix tank with water, pesticide, fertilizer, surfactant /additives and agitate.
- Step 3.Shake bottle well before using.
- Step 4.For best mixing results, either
- inject POINTBLANK® WM liquid into the suction side of the feeder or recirculating pump to obtain adequate dispersion of the polymer throughout the pesticide solution, or
- slowly add POINTBLANK® WM liquid to the agitating tank mix at the area of highest turbulence.
- Step 5.Continue to agitate mix tank for at least 3 minutes before spraying.
- Step 6.Follow all cleanup precautions on label of pesticide used. Follow governmental procedures for disposal of pesticide spray solution.
DOSAGE CHART Spray Pressure Nozzle Orientation POINTBLANK® *Dosage Aerial applied (below 45 psi) Straight back
45° angle back2-6 oz / 100 gals 4-8 oz / 100 gals Ground Application Low (below 30 psi) Flat Fan, Flooding
Off-center1-4 oz / 100 gals 3-5 oz. / 100 gals Medium (30-50 psi) Flat Fan, Flooding 3-4 oz / 100 gals Off-center 4-6 oz / 100 gals Spray guns 5-8 oz. / 100 gals High (over 50 psi) Spray guns 8-32 oz / 100 gals Higher spray pressure or greater agitation requires higher rates to maintain good drift control. If unacceptable drift is still occurring, add additional POINTBLANK® WM in increments of 1 oz. per 100 gal. of spray solution
Properties
- Formulation Type
- Physical Form
Safety & Health
- Hazards to Humans and Domestic Animals
- NOT FOR AQUATIC USE IN WAMay be harmful if swallowed. Causes skin irritation. Causes eye irritation. Keep out of reach of children. Read label before use. Keep container tightly closed. Keep only in original container. Do not breathe dust / fume / gas / mist / vapors / spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Do not induce vomiting. Take off contaminated clothing and wash it before reuse.
- Personal Protective Equipment (PPE)
- Wear chemical-resistant gloves, coveralls worn over long-sleeved shirt and long pants, and shoes plus socks. Wear protective gloves/protective clothing/ eye protection/ face protection
Packaging & Availability
- Packaging Type
Storage & Handling
- Storage and Disposal
- DO NOT CONTAMINATE WATER, FOOD, OR FEED BY STORAGE OR
- DISPOSALSTORAGE: Keep from freezing. Store in a cool well-ventilated place. Keep in original container tightly closed. Do not reuse empty container. Do not store with food, feed, or other material to be used or consumed by humans or animals. Do not contaminate water supplies. For optimal storage, store between 40° and 90° F.
- DISPOSAL: Do not contaminate water, food or feed by storage or disposal. Dispose of contents in container to an approved waste disposal facility in accordance with all federal, state and local regulations. Triple rinse (or equivalent) adding rinse water to application tank. Offer container for recycling or dispose of in a sanitary landfill or by other procedures approved by local regulations