Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
- Components
- Single Part Product.
- May be thinned for application using IP985-Reducer or IP9151.
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Uses
- Used on, for example spherical bearing surfaces to protect against frottage corrosion and on bolts for torque and gives an exceptionally good rubbing wear resistance. When used on bolts, it increases torque end loads.
- It is also used on turbine blade roots and fir trees where it reduces the likelihood of the disk splitting.
- Application
Surface Preparation
Ensure that surfaces are clean and free from dirt.
Paint Preparation
Stir well before use. All separated material must be reincorporated into the bulk product. No time limits are specified for the mixing operation. The operator must be satisfied that the product including any thinning solvent is thoroughly mixed before use. Where mechanical mixing is employed care must be taken to not heat the product above the maximum storage temperature. Mixing in open containers should be limited to <10-minute periods to ensure that solvent evaporation does not compromise the product. Shaking or rolling in closed containers is an acceptable mixing method for small volume products supplied ready for use.
Application Method
- Spray a light coat and allow to dry for 10 - 20 minutes at room temperature, 15 - 30 °C, stove for 2 - 2.5 hours at 375°F. Where spraying is not possible small areas may be coated by brush.
- Part cure procedure – where components require coating on multiple faces and/or multiple masking procedures, IP9136-R3 may be part cured to allow handling.
- For this process a baking schedule of 30 - 40 minutes at 142 - 158 °C may be used. The low bake allows parts to be handleable only. Full curing of the coating is only achieved after the full baking cycle.
Drying Curing
- Air Dry for 10 - 20 minutes at room temperature
- 15 - 30°C, then stove for 2 - 2.5 hours at 375°F.
- Solvent/Cleanup
40006 Gun Clean
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Supply Viscosity | Ready for Use | — | — |
| Flash Point | 27.0 | °C | — |
| Density | 1.03 | kg/l | — |
| Catalyst | Ready for Use | — | — |
| Theoretical Coverage (25 Microns) | 13.5 | m²/l | — |
Regulatory & Compliance
- Approvals/Specifications
- MSRR 9276
- OMat 4 / 44C
- CPW 27
- Alternative to the no longer made PL239 (3862X9010) AFS473, which superseded PL94 in about 1984.
Technical Details & Test Data
- Performance
Resistant to dry heat up to 400°C in oxidizing atmospheres and 500°C where oxygen is excluded, ester lubricants, Skydrol and corrosion.
- Tri-n-Butyl-Phosphate - 3 hours at 70°C
- Dry Heat - 1000 hours at 400°C
Packaging & Availability
- Pack Size
- 1 Liters
- 5 Liters
Storage & Handling
- Storage
- Highly flammable liquid - Store and use in accordance with the flammable liquid regulations.
- Shelf Life - 12 months temperate; 6 months tropical