Knowde Enhanced TDS
Identification & Functionality
- Composition
- Mixture of solvents and additives
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Advantages
- Excellent degreasing and cleaning effect
- Protective film against corrosion
- Can be rinsed with water
- Short emulsion time in oil-water separators
- Slow evaporation rate
Applications & Uses
- Markets
- Applications
- Applications
Cleaning and (cold) degreasing of chains, gears, bearings, motors, machines, conveyors, sliding surfaces, steel plates, (ship) floors and many other surfaces and machine parts.
- Instructions For Use
- Do not dilute the product. Interflon Degreaser EM56+ can be applied manually (i.e. brush) as well as by plunging or spraying. The best result is obtained by first applying the cleaner for 10 to 20 minutes and then brush or wipe off. If required, rinse the surface with water. Does not affect lacquer and synthetic material. Also NBR and neoprene rubbers are not affected. Can be sprayed using a trigger spray. The trigger spray will perish in time.
- It is advisable to test a small inconspicuous area to make sure that the cleaning agent does not adversely affect or damage the surface being cleaned. Do not apply to hot surfaces. When cleaning large vertical areas, apply the product from the bottom and work upwards ensuring that the whole area is covered. Cleaning away any dirt is best done from the top in a downwards direction to prevent leaving any streak marks. Do not use the product or allow to dry in direct sunlight.
Properties
- Physical Form
- Odor
- Characteristic
- Typical Properties
Value | Units | Test Method / Conditions | |
Density (20°C) | 0.76 | g/cm³ | — |
Highest Application Temperature | 40.0 | °C | — |
Evaporation Speed (n-BuAc= 1) | 0.06 | — | — |
Vapour Pressure (20°C) | 0.6 | hPa | — |
Regulatory & Compliance
- Certifications
- Halal,Kosher
Packaging & Availability
- Packaging Type
Storage & Handling
- Shelf Life
- 2 years
- Storage
Storage temperatures should be less than 0°C need to be avoided to guarantee product quality.