Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Features
- 7038 Blaze Cotton White™ is very creamy, short-bodied and very opaque, resulting in excellent coverage on dark garments.
- It is formulated to be a high-performance, opaque underlay.
- Very good flash.
- Very good opacity.
Applications & Uses
- Markets
- Application Method
- Cure Method
- Spot Flashing
7038 Blaze Cotton White™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused. Totally fusing the underprint white may cause inter-coat adhesion problems with the inks printed on top of the white ink. Final fusing or curing should occur in the dryer.
- Important Information
7038 Blaze Cotton WhiteTM was formulated for use on 100% cotton fabrics. It is not a low bleed ink. On some types of cotton fabrics that have been over-dyed, poorly dyed or stone washed, dye migration or bleeding may occur. Always test print the actual fabric to be printed before beginning production. It is best to do some long-term testing on fabrics to determine if there is going to be any dye migration or bleeding problems. Dye migration or bleeding may not occur right away.
7038 Blaze Cotton WhiteTM was formulated to make printing opaque white easy. Hand printing is less tiring because less squeegee pressure is needed. The result is improved operator performance. Automatic equipment can be adjusted to lower pressure settings, thus improving screen life and squeegee durability.
Ghosting, or fabric discoloration, should not occur when using this product on 100% cotton fabrics. Always test for ghosting, dye migration or bleeding on any 100% cotton fabric before beginning production.
Adding any reducers or additives can lower bleed resistance, reduce opacity, or increase cure times of the ink. STIR the ink prior to printing on press and after addition of reducers or additives.
Test dryer temperatures and wash test printed product before and during a production run.
- Recommended Fabrics
100% Cotton
- Ink Application
7038 Blaze Cotton White™ should be used right from the container without any modifications.
- Additives
If modification is necessary, use 1% to 5% by weight of 1110 Curable Reducer.
- Clean Up
Any eco-friendly plastisol screen wash.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Screen Mesh | 60 - 230 | t/in | — |
| Emulsion (Direct/Indirect Emulsion, Capillary Film) | 35 - 70 | micron | — |
| Squeegee (Sharp Edge) | 65 - 70 | — | Durometer |
| Cure Temperature (1min) | 325.0 | °F | — |
| Bleed Resistance | 100 % Cotton | — | — |
Packaging & Availability
- Packaging Type
- Product Packaging
- 1 gallon containers
- 5 gallon containers
- 30 gallon containers
- 50 gallon containers
Storage & Handling
- Storage of Ink Containers
- 65º to 90ºF
- Avoid storage in direct sunlight Keep containers well sealed.