Knowde Enhanced TDS
Identification & Functionality
- HRAC/WSSA Group
- Agrochemical Functions
- Technologies
- Product Families
- Active Ingredient
BROMOXYNIL (present as an ester): 480g/L
Applications & Uses
- Markets
- Applications
- Application Technique
- Key Applications
Key Crops
- Wheat (Spring, Winter)
- Barley
- Oats
- Corn
- Summer fallow
Key Weeds
- Buckwheat (wild/common)
- Lambs’ Quarters
- Lady’s Thumb
- Smartweed
- Cocklebur
- General Information And Directions For Use
- Timing: for best results spray when weeds are in the seedling stage. Apply in good growing conditions. Application must be made before the crop shields the weeds.
- Sprayer: wash the tank and clean all filters, screens and tips. Select nozzle tips to apply the recommended volume of water per hectare. Flood jet type tips are not recommended. Adjust boom height to ensure uniform coverage of weeds. For ground application, spray at 5–10 km/h. Ensure that all tips are in good condition and spraying the same volume.
- Mixing: half fill the tank with clean water. Add the required amount of ipco brotex 4at liquid herbicide and agitate thoroughly. Fill the tank and agitate again before use. Field sprayer application: do not apply during periods of dead calm. Avoid application of this product when winds are gusty. Do not apply with spray droplets smaller than the american society of agricultural engineers (asae) medium classification. Boom height must be 60 cm or less above the crop or ground. Aerial application (wheat and barley only): aerial application: do not apply during periods of dead calm. Avoid application of this product when winds are gusty. Do not apply when wind speed is greater than 16 km/h at flying height at the site of application. Do not apply with spray droplets smaller than the american society of agricultural engineers (asae) medium classification. To reduce drift as this product is not registered for the control of pests in aquatic systems, do not use to control aquatic pests. Do not contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
- Aerial application (wheat and barley only): do not apply during periods of dead calm. Avoid application of this product when winds are gusty. Do not apply when wind speed is greater than 16 km/h at flying height at the site of application. Do not apply with spray droplets smaller than the american society of agricultural engineers (asae) medium classification. To reduce drift caused by turbulent wingtip vortices, the nozzle distribution along the spray boom length must not exceed 65% of the wing or rotorspan. Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rate and conditions of this label. Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment. Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices.
Properties
- Physical Form
Regulatory & Compliance
- Chemical Inventories
Safety & Health
- Precautions
- Keep out of reach of children. Causes eye irritation, do not get in eyes. Avoid contact with skin and clothing. Harmful or fatal if swallowed. Store the container tightly closed away from seeds, fertilizer, plants and foodstuffs. Wash concentrate from skin or eyes immediately. Wear goggles or face shield during mixing/loading. Do not use in residential areas, which are defined as sites where bystanders may be present during or after spraying, including homes, schools, parks, playgrounds, playing fields, and public buildings. Apply only when the potential for drift to areas of human habitation or areas of human activity such as houses, cottages, schools, and recreational areas is minimal. Take into consideration wind speed, wind direction, temperature inversions, application equipment, and sprayer settings.
- Ground applications: wear coveralls over a long-sleeved shirt, long pants, chemical-resistant gloves, socks and shoes during mixing, loading, clean-up and repair. Wear a long-sleeved shirt and long pants, chemical resistant gloves, and socks plus shoes during applications. Gloves are not required during application within a closed cab.
- Aerial applications: the field crew and the mixer/loaders: wear coveralls over a long-sleeved shirt, long pants, chemical-resistant gloves, socks and shoes during mixing, loading, clean-up and repair.
- Aerial applicators: wear a long-sleeved shirt, long pants, socks and shoes during application. Gloves are not required during application within a closed cockpit. Do not allow the pilot to mix chemicals to be loaded onto the aircraft. Do not enter or allow worker entry into treated areas during the restricted-entry interval (rei) of 24 hours.
- Do not apply this product in a way that this product will contact workers or other persons, either directly or through drift. Only handlers wearing personal protective equipment may be in the area being treated during application. Discard clothing or other absorbent materials that have been drenched or heavily contaminated with this product's concentrate. Do not reuse them.
- Users should remove clothing immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing. 3 avoid breathing spray mist. After use wash hands and other exposed skin. Avoid spray drift onto crops other than those recommended. If this pest control product is to be used on a commodity that may be exported to the u.S. And you require information on acceptable residue levels in the u.S., visit croplife canada’s website at: www.Croplife.Ca. This product contains a petroleum distillate which is moderately to highly toxic to aquatic organisms. Avoid contamination of aquatic systems during application. Do not contaminate these systems through direct application, disposal of waste or cleaning equipment. Avoid contamination of ponds, streams, rivers and other water sources.
- Pre-harvest grazing intervals (wheat, barley, oats, forage sorghum, forage millet and seedling alfalfa): do not use treated crops for grazing of livestock or green feed until 30 days after application of ipco brotex 4at liquid herbicide unless otherwise stated on the label. Do not cut treated crops for forage until 30 days after application of ipco brotex 4at liquid herbicide. Caution: do not graze other treated crops or cut for feed unless specified above; sufficient data are not available to support such use.
- Do not enter or allow worker entry into treated areas during the restricted-entry intervals (reis) specified in the following table:
- First Aid
- If swallowed, call a poison control center or doctor IMMEDIATELY for treatment advice. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give any liquid to the person. Do not give anything by mouth to an unconscious person.
- If on skin or clothing, take off contaminated clothing. Rinse skin IMMEDIATELY with plenty of water for 15–20 minutes. Call a poison control center or doctor for treatment advice.
- If inhaled, move person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably by mouth-to-mouth, if possible. Call a poison control center or doctor for further treatment advice.
- If in eyes, hold eye open and rinse slowly and gently with water for 15–20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a poison control center or doctor for treatment advice.
Packaging & Availability
- Availability
9.7 Liters
Storage & Handling
- Storage
- Store the container tightly closed away from seeds, fertilizer, plants and foodstuffs. This ipco brotex 4at liquid herbicide formulation will solidify at temperatures below -20°c but will become useable again at temperatures above 0°c.
- Insecticides and fungicides should be segregated from herbicides so as to prevent the possibility of cross-contamination. Shake well before using.
- Disposal
Recyclable container: do not reuse this container for any purpose. This is a recyclable container, and is to be disposed of at a container collection site. Contact your local distributor/dealer or municipality for the location of the nearest collection site. Before taking the container to the collection site:
- Triple- or pressure-rinse the empty container. Add the rinsings to the spray mixture in the tank.
- Make the empty, rinsed container unsuitable for further use. If there is no container collection site in your area, dispose of the container in accordance with provincial requirements.
Refillable containers: for disposal, this container may be returned to the point of purchase (distributor/dealer). It must be refilled by the distributor/dealer with the same product. Do not reuse this container for any other purpose. Disposal of unused, unwanted product: for information on disposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for cleanup of spills.