IPCO® MCPA Amine 600

Identification & Functionality

HRAC/WSSA Group

4

Agrochemical Functions

Herbicide

Technologies

Agrochemicals

Product Families

Agrochemicals — Crop Protection & Pest Control

Herbicides

Active Ingredient

MCPA (Present as Dimethylamine Salt) / Group 4 Herbicide

Applications & Uses

Markets

Agriculture & Feed

Applications

Agriculture & Feed — Agricultural Crops

Cereals,

Fodder & Forage,

Herbs & Spice Crops,

Sugar & Starch Crops,

Vegetables

Agriculture & Feed — Pest Control

Agricultural Pest Control

Applicable Crop

Barley,

Buckwheat,

Carrot,

Oats,

Wheat

Application Technique

Post-Emergence

Key Applications

Key Crops

• Wheat (Spring, Winter)
• Barley
• Oats
• Grass pasture
• Pre-seed/post-harvest/chem-fallow

Key Weeds

• Kochia
• Burdock
• Ragweed
• Redroot Pigweed
• Curled dock

Mixing & Application Instructions

1. Fill tank 1/2 full with water. Start agitation.
2. Add IPCO MCPA Amine 600. For tank mixes, add MCPA first, then the second herbicide.
3. Complete filling of tank with water.
4. Use 100-240 liters of water per hectare for application by ground equipment unless otherwise specified.
5. Do not exceed 275 kPa pressure for ground application.

• Field Sprayer Application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) coarse classification. Boom height must be 60 cm or less above the crop or ground.
• Aerial Application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) coarse classification. To reduce drift caused by turbulent wingtip vortices, the nozzle distribution along the spray boom length MUST NOT exceed 65% of the wing- or rotorspan.

Properties

Physical Form

Liquid

Safety & Health

Precautions

• Keep out of reach of children.
• Mixers, loaders, and applicators must wear a long-sleeved shirt, long pants, socks, shoes and chemical-resistant gloves. Aerial applicators and applicators using a closed cab are not required to wear chemical-resistant gloves.
• Avoid contact with eyes, skin and clothing. May cause skin irritation. Do not breathe spray mist or vapors.
• Sensitive Plants - Vegetables, flowers, grapes, fruit trees and other desirable plants are sensitive to MCPA even in minute quantities. Care should be taken to avoid spraying these types of plants or allowing spray mist to drift onto these plants during both their growing and dormant periods. Coarse sprays are less likely to drift. At higher temperatures, vaporization may cause injury to susceptible plants growing nearby.
• Do not spray when there is any danger of wind or on exceptionally hot days over 27˚C.
• Drift from spray may be reduced by using high volume sprays under low pressure, coarse sprays, and drop nozzles where possible. Use special care in aerial application where damage from drift can be greater.
• Do not contaminate any body of water. Avoid contamination of foods.
• Do not use in a greenhouse.
• Keep in original container during storage.
• Do not store near or in same room as seeds, feeds, fertilizers or pesticides used on crops sensitive to this product.
• Clean spray equipment thoroughly after use and rinse with clean water. Do not use spray equipment to apply other pesticides to crops sensitive to this product. Do not re-use empty containers.
• Do not enter treated areas within 12-hours after application for all agricultural scenarios, unless otherwise indicated.
• Do not permit lactating dairy animals to graze fields within 7 days after application.
• Do not harvest for forage or cut hay within 7 days after application.
• Withdraw meat animals from treated fields at least 3 days before slaughter.
• If this pest control product is to be used on a commodity that may be exported to the U.S. and you require information on acceptable residue levels in the U.S.

First Aid

• If on skin or clothing, take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. Call a poison control center or doctor for treatment advice.
• If in eyes, hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a poison control center or doctor for treatment advice.
• If swallowed, call a poison control center or doctor immediately for treatment advice. Have person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person.
• If inhaled, move person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably by mouth-to-mouth, if possible. Call a poison control center or doctor for further treatment advice.
• Take container, label or product name and Pest Control Product Registration Number with you when seeking medical attention.

Packaging & Availability

Availability

10 Liters

Storage & Handling

Disposal

Do not reuse this container for any purpose. This is a recyclable container, and is to be disposed of at a container collection site. Contact your local distributor/dealer or municipality for the location of the nearest collection site. Before taking the container to the collection site:

• Triple- or pressure-rinse the empty container. Add the rinsings to the spray mixture in the tank.
• Make the empty, rinsed container unsuitable for further use. If there is no container collection site in your area, dispose of the container in accordance with provincial requirements.