Knowde Enhanced TDS
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Compressive Strength | 60 | - | - |
| Density | 10 | - | - |
| Dielectric Constant 9375 | 1.2 | MHz | - |
| K-Factor | 0.3 | BTU in/hr ft F.. | ASTM D-256 |
| Loss Tangent 9375 | 3*10^-3 | - | - |
| Maximum operating temperature | 400 | °F | - |
| Modulus of Rigidity | 2300 | - | - |
| Shear Strength | 75 | - | - |
| Tensile Strength | 125 | - | - |
Technical Details & Test Data
- Typical Chemical Properties
- Processing Parameters
Blend T component into R component. Mix for about two minutes if spatula agitation is used, or 30 seconds if an impeller type mixing blade and drill motor (1,800 rpm) is used. Pour at perception of exothermic heat and slight decrease in viscosity. When foaming action has ceased, post cure immediately (One hour at 350°F, then by 25°F increments for one half hour per each increment until the maximum operating temperature plus 25°F is reached.) Cool part to 110-130°F before stripping from mold
Safety & Health
- Health and Safety Information
Safety Data Sheets are available which provide information concerning the health and safety precautions that must be observed when handling this product. Before working with this product, you must read and become familiar with the available information on the risks involved, proper use, and handing. All polyurethane foam burns in varying degrees, which in turn liberates toxic gasses; the foam should be evaluated in its final form for compliance to existing standards in your industry. Nothing contained herein grants or extends a license, express or implied, in connection with patents, issued or pending, of the manufacturer or others. The information contained herein is based on the manufacturer's own study and the works of others. The manufacturer makes no warranties, expressed or implied, as to the accuracy, completeness, or adequacy of the information contained herein. The manufacturer shall not be liable (regardless of fault) to the vendee's employees, or anyone for any direct, special or consequential damages arising out of or in connection with the accuracy, completeness, adequacy or furnishing of such information.
Storage & Handling
- Storage
Avoid moisture contamination during storage, handling, and processing. Store the polyol and isocyanate components from 65°F to 85°F. Do not expose isocyanate component to lower temperatures as freezing may occur
- Shelf Life
The shelf life is 12 months if stored in original unopened containers