Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
- Product Families
- Principal Functioning Agents
Ammonium sulfate, polyacrylamide, dimethylpolysiloxane 98.9% Constituents ineffective as spray adjuvants 1.1% Total 100.0% All ingredients are exempt from the requirements of a tolerance as specified in 40 CFR 180.
Applications & Uses
- Markets
- Application Technique
- Directions For Use
Ground Application: Apply Spray-Start at 9 to 12 pounds per 100 gallons of spray solution. Use the higher rate for enhanced spray deposition. Do not exceed recommended rate as restriction of nozzle pattern may occur.
Always read and follow the directions of the herbicide label that is being used with this spray adjuvant. If the herbicide label makes no recommendation for use of ammonium sulfate or nitrogen source, consult local agricultural authorities before use.
Mixing Recommendations
For greater deposition enhancement, use the higher range of recommended use rate for this product. Screen size in nozzle or line strainers should be no finer than 50 mesh. Maintain good agitation at all times until the contents of the tank are sprayed. If mixture is allowed to settle, thorough agitation is required to re-suspend mixture before spraying is resumed.
When using this product or any dry, water-soluble powder, always monitor spray pattern and regularly check line strainers to ensure that maximum spray pattern performance is achieved. Always make sure that dry powders are completely dissolved in the spray tank. If refilling a partially full tank, take care to avoid exceeding recommended use rate for this product
Mixing Procedures
- Fill spray tank one half full of water and begin agitation.
- SLOWLY add required amount of Spray-Start to the water at the point of maximum agitation. Vigorous agitation is required to disperse the product. Continue agitation until Spray-Start is completely dissolved.
- Continue filling while recirculating. Add herbicides and/or additional adjuvants as directed by the herbicide label. Always read and follow all label directions and observe all precautionary statements on the herbicide label.
Properties
- Formulation Type
- Appearance
- White Free-Flowing Granule
- Odor
- Slight Chemical
- Typical Properties
Value | Units | Test Method / Conditions | |
Net Weight | 9 | pound bags | — |
Flashpoint | Difficult To Burn or Continue Burning | — | — |
Solubility in Water at 20ºC | Soluble | — | — |
Storage Temperature | 32 | ºF | — |
Regulatory & Compliance
- DOT/IMDG Transporation
- Not Regulated
- Registered With CDPR
- No
- Registered With WSDA
- Yes
Safety & Health
- Hazard Statements
- May be harmful if swallowed.
- May be harmful in contact with skin.
- Causes mild skin irritation.
- Causes serious eye irritation.
- Precautionary Statements
- Wash hands, face and other affected areas thoroughly after handling.
- Wear protective gloves/clothing/eye/face protection.
- Call a poison center or doctor/physician if you feel unwell.
- If skin irritation occurs: get medical advice/attention.
- If in eyes: Rinse cautiously with water for several minutes.
- Remove contacts if present and easy to do; continue rinsing.
- If eye irritation persists: get medical advice/attention.
- First Aid
Call a poison control center or doctor immediately for treatment advice.
If In Eyes: Hold eye open and rinse slowly and gently with water for 15 to 20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye.
If On Skin: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15 to 20 minutes.
If Swallowed: Have the person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person.
If Inhaled: Move person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably by mouth-to-mouth, if possible.
- Environmental Hazards
Do not contaminate water sources by cleaning of equipment or disposal of wastewaters
Packaging & Availability
- Packaging Type
- Packaging
- 9 pound bag
- 220 bags per pallet
- 45 pound bag
- 40 bags per pallet
Storage & Handling
- Storage and Disposal
Storage: Store in a cool, dry place in original unopened bag. Do not contaminate water, food or feed by storage or disposal. If spill occurs, do not attempt to clean up with water, as area will become slippery. Simply sweep and dispose of material.
Disposal: Empty bags should be disposed of in a sanitary landfill or by incineration or by open burning if allowed by state and local authorities.