Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Application Method
- Preparation
Applied only on dry surfaces, protected from arising humidity and free of materials that might prevent bonding e.g. dust, loose particles, grease etc. The success in the application depends on the right preparation of the underlay and use of the material.
- Good, dry cleaning of the surface from dust and residues with vacuum cleaner and squeegees.
- Priming of the surface with RITIVEX (1102) for the proper adhesion of the sub-floor.
- Application of one or more layers until the surface is saturated. Avoid the creation of puddles of the material. Consumption: 200-300 gr/m2 in one layer, depending on the absorption of the underlay.
- When the primer starts to dry, apply ELASTOSPORT 853 in order to close the pores of the asphalt or cement surface
- As soon as the final layer of ELASTOSPORT 853 dries (after 24 hours at 25°C), apply CORRIDOL 864 in three layers, depending on the desirable thickness. It can be diluted maximum 2% water, depending on the temperature, in order to achieve better fluidity.
- Consumption
1.5 kg/m²(three layers)
- Application Tools
Squeegee.
Properties
- Appearance
- Viscous Liquid
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Density | 1.70-1.80 | Kg/lt | - |
| Full curing (Total Hardening for the Mechanical Resistance) | 5.0 | days | - |
| Temperature (For the Application and Drying of the Material) | 10-40 | °C | - |
| Time for the Hardening of the Material (25°C) | min. 24 | hours | - |
| Viscocity (25°C) | 19.0-25.0 | mPa.s | - |
Technical Details & Test Data
- Remarks
- During temperatures over 38°C, ideal time for the application of the material is between 22:00-9:00 a.m. while the minimum bearing temperature during application and drying should be 10°C.
- Thickness more than 0.5mm per layer may cause cracks in the summer, because high temperature causes the rapid evaporation of water and does not allow the material to dry normally. Coating thickness more than 0.5 mm is achieved only by repeated layers.
- Winds, frosts, rainfalls, and high temperatures should be avoided during the application and the day after (referring to rain and frost).
- If for any reason it gets damaged, it is simply repaired and recoated
Safety & Health
- Caution
The application must take place in well-aired places using protective gloves. Skin or eye contact must be avoided, otherwise wash carefully with soap and water.
Packaging & Availability
- Packaging Type
- Packaging
In drums of 25 kg, barrels 200kg.
Storage & Handling
- Storage
12 months in unopened containers in dry places with minimum temperature 5°C and high temperature 30°C (avoid sunlight).