Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Composite Materials Functions
- Plastics & Elastomers Functions
- Technologies
Features & Benefits
- Labeling Claims
- Materials Features
- Product Highlights
A thin film of Aqualease 75 provides excellent release, requires little or no mold maintenance, and provides better protection against rust on steel molds. This product is an excellent low cost replacement for organic solvent release agents.
- Features
- Water based carrier
- Excellent release
- Excellent film formation
- No build-up
- Low toxicity and odor
- No volatile organic solvents
- Reduced health risks
- Low mold maintenance
Applications & Uses
- Markets
- Applications
- Compatible Polymers & Resins
- Applications
- Dilute 1 part Aqualease 75 with 4 parts water, and preheat molds to operating temperature.
- Spray using an air assisted gun. Always apply a light coating before each molding cycle. Excess water will create surface defects on the molded parts.
- Should mold build-up occur, dilute Aqualease 75 blend as above in instruction 1 with an additional part of water.
- Aqualease 75 is a stable water emulsion of silicone polymers, but repeated or prolonged freezing may cause separation. Should this occur, mix well before using. This product will freeze at 32°F.
- Finishing
Thorough cleaning of molded parts is required prior to staining, painting or bonding. Clean solvent such as mineral spirits will remove any residual oils on the parts surface. In addition, hot alkaline power wash units will remove the release compounds.
Properties
- Physical Form
- Appearance
- Milky Fluid
- Typical Properties
- Properties
Application
Spray
Mold Temperature
All
Mold Types
All
Value | Units | Test Method / Conditions | |
Solids | 18 - 20 | — | — |
Viscosity | Low | — | — |
Regulatory & Compliance
- Chemical Inventories
Safety & Health
- Caution
- Use adequate protection when handling any release solvent systems.
- Skin contact my cause dryness.
- Wear safety glasses or their equivalent to prevent eye injury.
- Avoid inhalation of excessive amount of solvent vapor.