Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Feature
Asbestos free
Applications & Uses
- Applications
- Compatible Substrates & Surfaces
- Material Preparation
Always stir 20-07 before using.
- Limitations
Do not apply below 40°F or above 110°F. The solvent in 20-00 may attack some plastic foams. Test compatibility before using.
- Application
This product is for industrial use only. It should be applied by trained and qualified craftspeople. Be sure surfaces are clean and dry before application. Using a brush or air atomizing spray equipment, apply 20-07 in a thin even coat to both surfaces. Before bonding, the contact cement should dry to touch. Press the surfaces together. The longer the joint is allowed to dry, the stronger the bond,. There is no repositioning. This is a contact cement.
- Clean Up
Trichloroethylene or Xylol.
- Coverage
200 sq.ft./gal. of surface to be adhered. The coverage rate is dependent on the surface being covered and the application method.
Properties
- Physical Form
- Typical Properties
- Flammability
Value | Units | Test Method / Conditions | |
Service Temperature | -20 to 220 | °F | — |
Weight | 6.7 | lbs/gal | — |
Non Volatile (Average) | approx. 20 | % by Weight | — |
Bonding Time (Depend on Temperature, Humidity, Film Thickness) | 0 - 25 | min | — |
VOC | 3.47 | lbs/gal | — |
Value | Units | Test Method / Conditions | |
Flash Point (Wet, Flammable) | -4.0 | °F | — |
Threshold Limit Value (Vapor) | 50.0 | ppm | — |
Regulatory & Compliance
- Certifications & Compliance
- Specification Compliance
MIL-A-24179A Type II Class 1
Safety & Health
- Caution
- Flammable mixture
- Red Label
- Do not use or store near heat, sparks or open flame.
- Use with adequate ventilation.
- Avoid prolonged or repeated breathing of vapor.
- Avoid prolonged or repeated contact with skin.
- Do not take internally. In an emergency, call a physician.
- Keep out of reach of children.
- Surface Burning Characteristics
Applied to Inorganic Reinforced Cement Board
USC CNC Flame Spread 10 10 Smoke Developed 0 0
Tested as applied at a coverage rate of 200 sq.ft./gal Flash point of finished adhesive (closed cup), less than -20°C.