Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Plastics & Elastomers Functions
- Technologies
- Product Families
Applications & Uses
- Applications
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Usage Notes
The material should be processed at room temperature. Nexa3D xMODEL 2505 should be well mixed before each print job, color deviation or failed prints might occur when not mixed thoroughly. It’s recommended to use a bottle roller (roller bench) for mixing with suitable ceramic beads for at least 30 minutes. Pour it slowly in the vat and wait a couple minutes, until the bubbles are gone before starting the print job.
Keep container tightly closed in a room temperature, well-ventilated place. Keep container dry. If Material is not being used fill it back through a filter in the corresponding material bottle. The filter prevents to fill cured pieces or failed prints back into the bottle. Uncured Nexa3D xMODEL 2505 must be disposed of or incinerated in accordance with local regulations.
The mechanical and physical properties of Nexa3D xMODEL 2505 are highly dependent on the printing parameters used as well as part geometry. It is common that validated workflows need to be adjusted for unusually thick or thin geometries.
Properties
- Color
- Mechanical Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Tensile Stress at Break | 54 | MPa | ASTM D638 |
| Young’s Modulus | 2500 | MPa | ASTM D638 |
| Elongation at Failure | 4 | % | ASTM D638 |
| Flexural Strength | 83 | MPa | ASTM D790 |
| Flexural Modulus | 2150 | MPa | ASTM D790 |
| Value | Units | Test Method / Conditions | |
| Hardness | 73 | Shore D | ASTM D2240 |
| Viscosity (30°C) | 80 | mPas | Cone/Plate Rheometer |
| Liquid Density | 1.1 | g/cm³ | ASTM D4052-18a |
| Solid Density | 1.2 | g/cm³ | ASTM D792 |
Technical Details & Test Data
- Validated Workflows
Exposure Parameters NexaX default Primary Wash 2min, Isopropyl Alcohol Secondary Wash 2min, Isopropyl Alcohol (low saturation) with Ultrasonic Dry 30min air dry Cure 30min in xCure, ambient temperature Exposure Parameters NexaX default Primary Wash 3min, distilled water Ultrasonic bath Secondary Wash 3min, distilled water (low saturation) Ultrasonic bath, soft brush if needed Blow Off Blow dry with pressurized air Dry 30min dry in 40°C warming cabinet Cure 30min in xCure, ambient temperature Exposure Parameters NexaX default Primary Wash 2min, xClean in xWash station low agitation speed Dry 10 min drip dry Secondary Wash 2min, Isopropyl Alcohol (low saturation) with Ultrasonic Dry 30min air dry Cure 30min in xCure, ambient