Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Advantages
Solvent free, 100 % solids
Resistant to chemicals
Excellent adhesion to concrete and asphalt
Excellent wetting and bonding capability to substrate and reflective media
Suitable for manual applications of symbols and where continuous run is impractical
Applications & Uses
- Markets
- Applications
- Use
May be used for reflectorized pavement markings on asphalt, concrete and other surfaces along with reflective media. Can be used for new construction and maintenance with adequate surface preparation and as per specifications.
- Surface
Clean to remove contaminants such as water, loose residual from grinding etc. Remove lose debris by vacuum or blow with dry compressed air. For best results, old markings and contaminants should be removed using scarification or grinding.
- Application
Mechanical: Volumetric, positive displacement measuring, mixing and dispensing equipment must be used. Equipment shall be capable of conditioning components stored in independent tanks and consistently measure as per prescribed mix ratio, mix and dispense liquid to be sprayed on prepared surface mechanically. Equipment shall have capability to monitor proportions of two components as per manufacturer and will be capable of mechanincally ditributing reflective media evenly across width of markings. Static mixing and impingement are acceptable methods of mixing. Mil thickness and bead application rate shall be accoding to applicable specifications.
- Limitations
Do not dilute with any solvent or thinner
Aplly when surface and ambient conditions are 35°F and rising for proper cure
Properties
- Technical Data
| Value | Units | Test Method / Conditions | |
| Bond Strength | min. 250 | psi | - |
| Compressive Strength | min. 10000 | psi | ASTM D 695 |
| Gel Time | 8 - 10 | Minutes | 100 grams |
| Mix Ratio (Part A, Volumes) | 2.0 | - | - |
| Mix Ratio (Part B, Volumes) | 1.0 | - | - |
| Temperature (Liquid Components) | max. 140 | °F | - |
| Tensile Strength | min. 5000 | psi | ASTM D 638 |
| Wear Resistance | max. 90 | - | ASTM D 4060 |
Safety & Health
- Safety
Caution:
Part A: Contains Epoxy Resin. Skin and eye irritant. Prolonged contact can cause sensitization.
Part B: Contains Corrosive Amines. Skin and eye irritant. Can cause severe burns when in contact with skin and eyes. Use proper clothing and respirators. Consult Safety Data Sheet for details.First Aid:
Remove contaminated clothing. Wash thoroughly with water and soap. If contact with eyes, irrigate with water for 15 minutes and consult physician. Remove to ventilated area. If ingested, do not induce vomit, seek medical attention immediately. Consult Safety Data Sheet for details.
Packaging & Availability
- Packaging
IBC also available
15 Gallons (10 Part A and 5 Part B) Pails
150 Gallons (100 Part A and 50 Part B) Drums