Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Polymer Name
- Plastics & Elastomers Functions
- Technologies
- Product Families
Features & Benefits
Applications & Uses
- Applications
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications
Prime ABS ST80 is particularly suited for use in exterior applications or
those interior parts that will be exposed to direct UV light such as
dashboards, panels and trim. This includes marine, recreational, automotive,
heavy truck, agricultural and construction equipment.- Processing
Prime ABS ST80 can be thermoformed on conventional equipment employing
techniques typical for thermoforming ABS. Male or Female tools may be
used. Prime ABS ST80 should be heated only from the substrate side. As long
as the substrate reaches a temperature suitable for thermoforming, the soft
touch cap layer will also be hot enough to thermoform. The soft touch cap
layer should not be heated to a temperature above 315 315°F. The best appearance
and performance of the soft touch cap layer has been obtained when the sheet
is thermoformedwith the temperature of the cap layer at 280 280°F. As a general
rule, heating rates of 0.5 0.75 sec/mil are the maximum recommended for
thermoforming ABS.
Properties
- Typical Properties
Value | Units | Test Method / Conditions | |
Vicat Softening Point | 221 | ºF | D-1525 |
CLTE | 5.310 5 | In/in/°F | D-686 |
Elongat ion at Yield | 7 | % | D-638 |
Flexural Modulus 0.05 in/min, 2” span | 1,18,000 | psi | D-790 |
Gloss, 60 º Angle | 2.5 | % | D-523 |
Hardness, initial | 53.2 | Shore D | D-2248 |
Hardness, Initial | 53 | Shore D | D-2240 |
HDT at 264 psi, Un annealed | 178 | ºF | D-648 |
HDT at 66 psi, Un annealed | 200 | ºF | D-648 |
Melt Flow | 3.03 | g/10min | D-1238 |
Notched Izod at 73 ºF | 9.3 | ft lb/in | D-256 |
Specific Gravity | 1.042 | g/cc | D-792 |
Surface Resistivity | 1014 | Ohms/ square | - |
Ultimate Elongation | 10.03 | % | D-638 |
Ultimate Elongation | 3590 | psi | D-638 |
Technical Details & Test Data
- Finishing
Prime ABS ST80 can be screwed, drilled, routed, punched and die
cut with
conventional tooling. Parts made with Prime ABS ST80 may be joined with
machine screws, bolts, nuts, rivets, and spring steel fasteners. Thread cutting
or thread forming screws are an economical means of securing separate
joints. Formed parts may be joined with Methylene Chloride if maximum
impact strength is not required. Press and snap techniques and sonic welding
may also be used for the bonding of Prime ABS ST80.
Packaging & Availability
- Colors, Textures and Capabilities
Prime ABS ST80 can be color matched to meet your specific
requirements .
Textures include Calf Grain, HC, Seville, Levant I, and FL/HC.