Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Advantages
- Fast Tack
- Good Heat Resistance
- Low Odor
- Very Low VOC
- Lacquer Resistant
- High Initial Strength
- Soft Bond Line
- 5 Minute Open Time
- Toluene Free
- California Compliant
- Web Spray
Applications & Uses
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Developed For
- Carpet
- Fabric
- Foam
- FRP Reefer Liners
- Insulation
- MDF
- Plastics
- Rubber
- Standard Laminate
- Synthetic Leather
- Veneers
- Application Type
2 sided
- Direction For Use
This product is designed to be applied to both bonding surfaces.
- Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc.
- For best results, the temperature of the adhesive and the surfaces being bonded should be between 16ºC - 27ºC. Use with adequate ventilation.
- When possible we recommend shaking the canister or aerosol well before using.
- Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
- Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates.
- Spray about 10-20 cm away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive.
- If using a two way stick, spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
- Adhere surfaces and press together with adequate pressure. If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or TensorGrip® S105 acetone cleaner. Do not use a pin on the spray tip orifice
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| VOC Content | 80.0 | g/L | — |
| 90° Peel | min. 25 | PLI | — |
| Shear Adhesion Failure Temp (25mm/100gram_ 105°C) | Heat resistance | — | — |
| System Flammability | Flammable adhesive with a non-flammable propellant | — | — |
| Solvent | Methyl Acetate | — | — |
| Dry time | 2021-01-02 | mins | — |
| Open time | 2021-05-15 | mins | — |
Technical Details & Test Data
- Square Meter Coverage (m2)
22 ltr Cannister 230 500ml Aerosol 7
Packaging & Availability
- Packaging Type
Storage & Handling
- Shelf Life
- 18 months from date of manufacture
- Canister Storage/Change Over
• Consult Material Safety Data Sheet prior to use.
• Do not store at temperatures over 50°C.
• Avoid exposure to direct sunlight.
• Do not store directly on concrete floor.
• Always store above 15°C
• When connected, keep valve open and hose pressurized at all times
• Always test our adhesives to determine suitability for your particular application prior to use in production